Secure fastening solutions for foamed components EJOT® EPPsys DR Thread exterior-0 Thread length Head-0 Total head height Internal drive Material Colour The EJOT® EPPsys (EPP System) has been developed to fasten parts to foamed components, especially EPP (expanded polypropylene). EJOT® EPPsys DR The EPPsys DR (Direktverschraubung = direct assembly / Rasthaken = snap-fit) combines the advantages of the EPPsys D with an alternative for subsequent component attachment. Two engagement hooks enable the easy attachment of thin-walled components. Advantages of the EJOT® EPPsys DR • All assembly features of the EPPsys D screw are valid • Easy, subsequent attachment of EPP components to thin-walled components • Easy and secure snap-fit of the mounted parts • Large clamping thickness range • Axial tolerance compensation within the clamping thickness range • Radial tolerance compensation Requirements for the clamping part Hole-0 recommendation 11 +/- 0,1 mm Minimum clamp thickness 0,8 mm Maximum clamp thickness 2,2 mm * Ms greater than 2,7 Nm - failure of the internal torx For more information please contact Tony Wiegandt, phone +49 36252 42-361, fax 42-328, e-mail [email protected] 10.2010 subject to technical changes.