The new EJOT DELTAsert® made of aluminium permits a reliable assembly into highly loaded thermoplastic components, which was only possible with pre or post moulded inserts before. However the recent demand for further cost and weight savings calls for new fastening solutions. The EJOT ALtracs® screw can be fastened as a selftapping screw into the EJOT DELTAsert® or as traditionel version with an M6 innertherad and a metric screw. An easy and process capable assembly is therefore guaranteed. The advantages of the EJOT DELTAsert® 60: • easy screw installation • weight reduction • high pull-out force • high break loose torque • also useable with thermosets • short assembly time EJOT The alternative to conventional insert applications EJOT DELTAsert® 60 for self-tapping EJOT ALtracs® screws Self-tapping assembly EJOT0 The Quality Connection

1. The EJOT DELTAsert® is assembled with a self-tapping thread into the plastic tube with a conventional screw driver and a rotation speed of approx. 500 rpm. According to the plastic material a tightening torque of [MA] from 10 to 12 Nm is recommended. For this the EJOT® DELTAsert is attached to the TORXplus® bit 2. with guiding pin (45IP). This can be done manually or also with the respective feeding unit. The guiding pin enables the axial fastening of the EJOT DELTAsert® into the boss. After installation an immediate further processing is possible. 3. There are no holding times for cooling...