LEDCure™
6Pages

EIT s LEDCure™ series of radiometers constitute a new family of highly portable and accurate radiometers designed specifically to measure the irradiance (W/cm2) and energy density (J/cm2) generated by industrial UV LED systems. The instruments take measurements in the same environment as the work pieces undergoing UV curing or treatment. The LEDCure™ is easy to use, compact and affordable. With its patented Total Measured Optical Response (TMOR™) the LEDCure™ provides absolute energy measurements with accuracy and repeatability comparable to larger, cabled, metrology-based instruments that are much more expensive. DESIGNED AND MANUFACTURED IN EIT FACILITIES IN THE USA WWW.EIT.COM

(Actual Size) LEDCure™ MEASUREMENT SIDE

Total Measured Optical Response (TMOR™) Patented EIT optics1 in the LEDCure™ are designed specifically to support UV LED Measurements. Each L-Band response is nearly flat over the range of its optic response. AH optical components in the measurement path characterization (not just the filter) are included in the LEDCure™ L365, L385, L395 and L40S instrument optical response. The TMOR™ LEDCure™ is the only portable radiometer that measures absolute LED energy without requiring extraordinary calibration methods. TMOR™ in the LEDCure™ provides: • Highly accurate readings run-to-run • Highly...

Reference Mode allows user to compare present reading with previously recorded values. LEDCure™ Versions: Standard & Profiler EIT’s LEDCure™ instruments function in the high energy UV environment. Two versions, STANDARD and PROFILER are available in L365, L385, L395 and L405. Features of the STANDARD and PROFILER versions are described below. STANDARD The STANDARD LEDCure™ provides peak Irradiance (’ cm2), Energy Density (J/cm2) and a low-resolution Irradiance Profile on the instrument display. EIT’s LEDCure™ features include: • SINGLE EIT L-BAND: Specified at time of order (L365, L385,...

Accuracy A 395nm, 10W LED source was set up so that the source output power could be measured by an L395 LEDCure™ and the results compared to those obtained from a Laboratory standard with integrating sphere. L395 performance is indistinguishable from the larger, less convenient, and more expensive Laboratory standard which cannot be used in a typical UV curing environment.1 The source intensity was varied by changing the working distance (distance between source and workpiece). Run Number The measurements, in mW/crri1, were recorded and plotted for each radiometer in each of 22 runs...

Full Specification Operating Range This equipment is in conformity with the following standards and therefore bears CE marking: IEC 61326-1:2005, EN55077:7998, EN67000-4-2: 7995, A7: 7998, A2:2007; EN 67000-4-3:2002, A7:2002, following the provisions of the applicable directives: 98/34/EEC and amendments, 89/336/EEC and amendments. Specifications subject to change without notice p/N IM-0104; Rev B, LEDCure Brochure August 2079 EIT LLC 309 Kelly’s Ford Plaza, SE Leesburg, VA 20175 703-478-0700 www.eit.com • uv@eit.com