Technical Summary for Bio-Pharm Fittings • Product: Stainless Steel fittings comply with ASME BPE standard. • Sizes: ½” – 6” O.D. tube size. • Material: AISI 316L Stainless Steel with sulfur content of 0.005-0.017%.

Dimensions & Tolerances: Dimensions as specified in ASME BPE Part DT. Neumo Ehrenberg Group

( Table SF-4 Ra Readings for Fittings^) GENERAL NOTE: All Ra readings are taken across the lay, wherever possible. NOTE: (1) The average Ra is derived from readings taken at four cross sections approximately 90 deg. apart. No single reading exceeding Ra max. Neumo Ehrenberg Group Surface Finish: Surface finish as specified

BPE Fittings Specifications • Cleaning: • Seven-step cleaning cycle. • Double-rinsed using hot DI water at a final stage. • Inspection Procedures: • 100% visually inspected according to Table SF-3. • 100% dimensional characteristics inspection according to Table DT-5 . • Verification of heat number traceability for accuracy and chemical composition, per Table DT-3.

BPE Fittings Specifications • Marking: Each fitting is marked as follows: • Heat number • Job number • Size • Material grade • Standard • Surface finish (SFF), as specified in part DT. • Brand name • Packaging: Each fitting is capped, bagged and labeled in full compliance with ASME BPE standard. • Documentation: Full Material Test Reports are supplied along with the finished goods, or via an interactive internet website, using a special private code.

Neumo Ehrenberg Group Stainless Steel Tubing (Pharmaceutical Industries) Seamless Tubing Seamless Austenitic Stainless-Steel Sanitary Tubing. Referenced documents: ASTM A450 / ASTM E112 Tubing intended for use in the pharmaceutical industries. Stainless steel 316L with sulfur content of 0.005-0.017% In accordance with ASME BPE requirement.

Neumo Ehrenberg Group 6. Nominal outside diameter:

Technical Summary for JZJ _.^JJJv_J Stainless Steel Tubing (Pharmaceutical Industries) Welded Tubing Neumo Ehrenberg Group Welded Austenitic Stainless-Steel Sanitary Tubing. ASTM A270 Referenced documents: ASTM A450 / ASTM E112 Tubing intended for use in the pharmaceutical industries. Stainless steel 316L with sulfur content of

5. Manufacturing: In accordance with BPE ASME Requirement. 6. Nominal outside diameter: 25.4 mm (1”), 38.1 mm (1 ½”), 50.8 mm (2”), 63.5 mm (2.5”), 76.2 mm (3”), 101.6 mm (4”) 7. Wall thickness (mm) 7.1 Tolerance (0.065” +10%) 1.65 + 0.165 (0.083” +10%) 2.1 8. Surface Finish: Internal: 20 RA or better. External: 180 Grit. +0.210 1” - 3” 4”

(Table SF-2 Ra Readings for Tubing) GENERAL NOTE: All Ra readings are taken across the lay, wherever possible. NOTE: (1) The average Ra is derived from readings taken at four cross sections approximately 90 deg. apart. No single reading exceeding Ra max. Neumo Ehrenberg Group