ES1-CO-10-01 Carbon Monoxide Gas Sensor

Product catalog summary

Overview: The ES1-CO-10-01 Carbon Monoxide Gas Sensor utilizes solid polymer electrochemical gas sensing technology, designed for various applications including industrial safety, leakage detection, and air quality monitoring.

Technical Specifications:

Performance: Sensitivity is 35 nA/ppm ± 15 nA/ppm, with a zero current of ± 100nA. The sensor range is 0-10ppm, with a maximum overload of 100ppm and a resolution of 0.01ppm. Response times are T50 < 10s and T90 < 30s, with repeatability < 1% and linear output.
Features: High selectivity, long lifetime (> 5 years), no-poisoning, fast response time, low power consumption, and RoHS compliance. Operates in a wide temperature range (-40°C to +55°C) with excellent sensitivity at low temperatures.
Operation: Amperometric, 3-electrode principle with a bias voltage of 0 mV and a recommended load resistor of 100 Ω. Warm-up time is less than 60 seconds.
Environment: Operating temperature range is -40 to +55℃, humidity range is 15-95 %RH (non-condensing), and pressure range is 800 to 1200 hPa. Storage temperature is 0 to 20℃.
Lifetime: Long-term drift is < 1 %/month, with an expected lifetime of over 5 years. Zero drift in clean air is < 0.2 ppm, and storage life is 12 months.
Housing: Made of PPO material, weighing less than 0.7g.

Cross Sensitivity: The sensor shows no response to various gases like acetylene, ethanol, ammonia, benzene, methane, carbon dioxide, chlorine, ethylene, hydrogen cyanide, hydrogen sulfide, nitric oxide, nitrogen dioxide, sulfur dioxide, and isopropanol at specified test concentrations, except for hydrogen which shows a reading of 150 ppm at 2000 ppm concentration.

Disclaimer: Performance data is based on test conditions and may change without notice. Users must ensure compliance with laws and regulations and are advised to check the module's response to target gases before use.

Warning: Avoid cleaning sensors with strong solvents and ensure proper disposal following local electronic waste regulations.

Catalog excerpts

ES1-CO-10-01 Carbon Monoxide Gas Sensor-1

Solid Polymer Electrochemical Gas Sensing Technology ES1-CO-10-01 Carbon Monoxide Gas Sensor Datasheet Easy Gas Sensor Solutions

Open the catalog to page 1

ES1-CO-10-01 Carbon Monoxide Gas Sensor-2

ES1-CO-10-01 Carbon Monoxide Gas Sensor Datasheet ES1-CO-10 Carbon Monoxide Gas Technical Specifications Performance Sensitivity Zero Current Maximum Overload Response Time Detects with high selectivity a wide variety of gases Long Lifetime > 5 years No-Poisoning Typical warm-up time in seconds Fast Response Time nA power consumption Linear Output No Zero Line Drift Better Signal to Noise Ratio Wide Temperature Range of-40°C to +55°C Excellent Sensitivity at low Temperatures No Leakage Small Size RoHS compliant Typical Applications Industrial Safety Leakage Detection Gas Manufacturing Process...

Open the catalog to page 2

ES1-CO-10-01 Carbon Monoxide Gas Sensor-3

ES1-CO-10-01 Carbon Monoxide Gas Sensor Datasheet Test Concentration Sensor Reading Carbon Dioxide Carbon Monoxide Hydrogen Cyanide Hydrogen Sulfide Nitric Oxide Nitrogen Dioxide Sulphur Dioxide Note: 1) The above interference factors may vary due to different sensors and service life, please refer to the actual test results. 2) This table is not complete for all cross gases. Please contact us for other gases. 3) The above parameters are the test results at a temperature of 25°C, a relative humidity of 50%RH and a normal pressure environment. The performance of the sensor varies under different...

Open the catalog to page 3

ES1-CO-10-01 Carbon Monoxide Gas Sensor-4

ES1-CO-10-01 Carbon Monoxide Gas Sensor Datasheet Temperature Curve Disclaimer The EC Sense performance data stated above is based on data obtained under test conditions using the EC Sense gas distribution system and AQS test software. In the interest of continuous product improvement, EC Sense reserves the right to change design features and specifications without notice. We are not responsible for any loss, injury or damage caused by this. EC Sense assumes no responsibility for any indirect loss, injury or damage resulting from the use of this document, the information contained therein or...

Open the catalog to page 4

ES1-CO-10-01 Carbon Monoxide Gas Sensor-5

Business Centre Europe and the rest of the world Business Centre Asia EC Sense GmbH Wangener Weg 3 82069 Hohenschäftlarn, Germany Tel: +49(0)8178-99992-10 Fax: +49(0)8178-99992-11 Email: [email protected] www.ecsense.com, www.ecnose.de Ningbo AQSystems Technology Co., Ltd. F4-17 Building, Zhong Wu Technology Park No.228, Jin Gu Bei Road, Yinzhou District NingBo, Zhejiang Provence, P.R. China Post Code: 315100 Tel: +86(0)574 88097236, 88096372 Email: [email protected] www.ecsense.cn, www.ecnose.de ES1-CO-10 Carbon Monoxide Gas Sensor_Datasheet_V1.2_20230425 Copyright@2023 EC Sense GmbH

Open the catalog to page 5

ES1-CO-10-01 Carbon Monoxide Gas Sensor

ES1-CO-10-01 Carbon Monoxide Gas Sensor

Catalog excerpts

All EC Sense GmbH catalogs and technical brochures