Catalogs >
EBRO ARMATUREN Gebr. Bröer GmbH >
LUG TYPE BUTTERFLY VALVE Z 614-C

LUG TYPE BUTTERFLY VALVE Z 614-C
4Pages

Catalog excerpts

LUG TYPE BUTTERFLY VALVE Z 614-C TECHNICAL DATA Nominal diameter: Flange accommodation: Flange Surface Design: API 609 Table 1 EN 1092 PN 10/16 ASME Class 150 EN 1092 Form A/B ASME RF, FF Tightness check: EN 12266 (Leakage rate A) ISO 5208, Category 3 Temperature range: -10°C to +120°C (depending on working pressure) Operating pressure: Lug type butterfly valve for shut-off and control services in the chemical industry. FEATURES - Environmental protection via EBRO-Safety seal - Split body with stainless steel screws - Isolation height according to plant prescription - Can be installed in any desired position - Maintenance-free - Can be disassembled, material-speciﬁc recycling possible - TA-Luft/ VDI 2440, RWTÜV certiﬁed DESIGN FEATURES - Optimized low torques - FEM dimensioned componets - Valve neck for 100mm isolation - Triple shaft bearing - One-piece shaft and disc - Double flat shaft acc. to EN standards Safety seal acc. to TA-Luft/ VDI 2440,RWTÜV.

Open the catalog to page 1

LUG TYPE BUTTERFLY VALVE Z 614-C Z 614-C with bare shaft end acc. to EN ISO 5211

Open the catalog to page 2

LUG TYPE BUTTERFLY VALVE Z 614-C MATERIAL SPECIFICATION AND PARTS LIST Lug type butterfly valve Z 614-C Nodular Cast Iron 2 Stainless Steel Scraper PTFE Bearing bush Type plate Stainless Steel Bearing bush Spiral spring Spring steel Lower shaft stub (DN 50 - DN 80 only) Stainless Steel * Other materials upon request Subject to change without notice

Open the catalog to page 3

LUG TYPE BUTTERFLY VALVE Z 614-C TORQUE - The values listed in the table are initial breakaway torques, taken with liquids and lubricant media. - Please regard these as approximate values, as the objective value depends on different factors like pressure, medium, rubber, quality, temperature ... etc. - Our engineers look forward to help you with exact values for your application. - Powdery (non-lubricant) media Md x 1,3 DN (mm) Size (in) Case of operation I MD (Nm) at ∆p=3 bar MD (Nm) at ∆p=6 bar MD (Nm) at ∆p=10 bar MD (Nm) at ∆p=16 bar Case of operation II MD (Nm) at ∆p=3 bar MD (Nm) at...

Open the catalog to page 4