Catalogs >
EBRO ARMATUREN Gebr. Bröer GmbH >
FULL FLANGE BUTTERFLY VALVE Z 014-WN

FULL FLANGE BUTTERFLY VALVE Z 014-WN
4Pages

Catalog excerpts

FULL FLANGE BUTTERFLY VALVE Z 014-WN - 1

FULL FLANGE BUTTERFLY VALVE Z 014-WN TECHNICAL DATA Nominal diameter: EBRO works standard Flange accommodation: EN 1092 PN 10 Special drilled holes upon request Flange Surface Design: Tightness check: EN 12266 (Leakage rate A) ISO 5208, Category 3 Design standard: Temperature range: -10°C to +200°C (depending on pressure, medium and material) Operating pressure: The full flange design of this valve series provides spaceless sealing with the counterflanges, so objectionable scaling is avoided. FEATURES - The valve body and disc are accurately machined which results in low operating torque and long service life and reliability - Triple shaft bearings prevent shaft deflection and guarantee optimum guidance even after many years of operating service - Can be disassembled, material-specific recycling possible - Single flange mounting is possible - Can be installed in any desired position - Maintenance-free - Full flange butterfly valve with an aluminum body GENERAL APPLICATIONS - Food industry - Pneumatic materials handling technology - Bulk goods technology - Pneumatic materials handling technology - Pharmaceutical industrie - Building material industrie Full flange butterfly valve Z014-WN with through going holes. Other hole patterns on request.

Open the catalog to page 1

FULL FLANGE BUTTERFLY VALVE Z 014-WN - 2

FULL FLANGE BUTTERFLY VALVE Z 014-WN □G E ØD Z 014-WN with bare shaft end according to EN ISO 5211 Subject to change without no

Open the catalog to page 2

FULL FLANGE BUTTERFLY VALVE Z 014-WN - 3

Version with splitted shaft Pt. Subject to change without notice

Open the catalog to page 3

FULL FLANGE BUTTERFLY VALVE Z 014-WN - 4

Subject to change without notice TORQUE - The values listed in the table are initial breakaway torques, taken with liquids and lubricant media. - Please regard these as approximate values, as the objective value depends on different factors like pressure, medium, rubber, quality, temperature ... etc. - Our engineers look forward to help you with exact values for your application. - Powdery (non-lubricant) media Md x 1,3 - Dry gases/high viscous media Md x 1,2 Kv-VALUES - The Kv-values [m3 per hour] is the flow of water at a temperature of 5°C to 30°C (41°F to 86°F) at Ap of 1 bar - The...

Open the catalog to page 4