QA/60C SERIES CONTROL PANELS AND STARTERS FOR 1 THREE PHASE MOTOR PUMP WITH DIRECT STARTING AND OVERLOAD AMMETRIC PROTECTION AND LEVEL CONTROL Electronic control panel READY FOR THE APPLICATION OF: MIC/1E-..V-2U in 3 versions: • interface module for control from an external device with power supply 12V or 24V ~ or 230V ~ clean output contacts • For models QA/60C QA/61C it involves the change of housing NOTE: you can use instead of the probes No. 2 float switches 1 OFF and 1 ON OPERATING CONDITIONS • Ambient temperature -5 / +40°C • Relative humidity 50% with a maximum temperature of 40°C Your Life, our Quality. Worldwide. The contents of this publication must not be regarded as binding. EBARA Pumps Europe S.p.A. reserves the right to effect any modification it deems necessary, without prior notice. TECHNICAL DATA • Power 3 ~ 50/60Hz 400V ± 10% • Extra low voltage input for external command from pressure switch or float switch • Extra low voltage inputs for probes, pressure switch or minimum float switch against dry running or too full • Selector for level probes (contacts NC for EMPTYING or NO for FILLING) • Selectors to full scale adjustment trimmer for regulation of probe tripping threshold (2-20K, 10-100K) • Trimmer for adjustment of the tripping threshold of the probes • Trimmer for the adjustment ammetric protection (overload) activation: the time of delay is approx. 3 sec • Selector switch for OFF-AUTOMATIC-MANUAL operation (this command has an automatic return) • LED light motor running (on) or motor protection (flashing) • Motor protection fuses • Auxiliary circuits protection fuses • Main disconnecting switch with door lock • Casing made of thermoplastic material • Protection degree IP 50