TESTING EQUIPMENT

OUR DYNAMICS SOLUTIONS CLASSIC SOLUTIONS • PNEUMATIC CYLINDER: F max < 1.000 N • HYDRAULIC CYLINDER WITH SERVO-VALVE: F max < 500.000 N NEW ELECTROMECHANICAL SOLUTION (DIRECT DRIVE) • DIRECT-DRIVE LINEAR MOTOR: F max < 10.000 N • DIREC-DRIVE WITH TORQUE MOTOR & BALL SCREW: F max < 500.000 N MAIN PLUSES of our DIRECT-DRIVE Solution (Green) • High Efficiency and Energy Savings due to Direct-Drive (No Crank System) • High Accuracy/No Backlash thanks to Ball Screws based on Ball Guide Line Systems • Energy Recovery System through Condensers + Brake Energy Regeneration, reducing Energy Consumption...

SOFTWARE & CONTROL SYSTEM EasyTester Software by Easydur is based on Windows 10 on a Beckhoff Hardware Platform, a PLC-typical Real-Time System (TwinCAT) combined with Windows versatility SOFTWARE STEPS • Pre-processing: Operator creates the Test Programme (fully customisable) Including: • All operations to be performed during the test run • All Testing & Result Conditions via selection of Force, Movement, Speed & Frequency Parameters and Acquisition Time • Processing: Test Run • Post-processing: Once the test is complete, all charts and desired values are shown on the PC screen. All results...

DIRECT-DRIVE LINEAR MOTOR Our Direct-Drive linear motor allows high speeds and accelerations to be achieved with low loads: • F max < 10.000 N • V max = 2,5 m/s • A max = 80 m/s2 (8G) Note: With increasing force and consequently decreasing speed/acceleration, an accurate technical evaluation is requi red at all times. DIRECT-DRIVE BALL SCREW Our system is based on Direct-Drive Ball Screws, and enables to reach high testing loads with great dynamic performance in terms of aceleration/speed and cost saving in comparison to standard hydraulic solutions. • F max < 500.000 N • V max = 0.5 m/s • A...