Eagle S135 Static Table Cutting System Go ahead. Get tough. Eastman’s static table system is capable of cutting, marking, drilling and punching virtually any flexible material at speeds of up to 60 inches per second (152.4 cm/sec.). The static cutting table has proven itself as the go-to resource for materials like cotton, nylon and vinyl as well as difficult-to-cut materials—such as polystrand, p-tex, and fiberglass-polyester blends. The static table system is available in a range of system lengths and widths to meet the demands for prototypes, one-offs and full-production runs. The system’s high-precision configuration features multi-axis motion for more defined and accurate cuts. Material is spread across the static table by an operator or with the use of a pneumatic gripper bar. The open plenum vacuum system design ensures evenly dispersed airflow for optimal material hold-down. This computer-controlled system features zoning capabilities to enable cutting in one area while the operator is simultaneously picking parts in another, maximizing daily production capacity. Cutting Surface Material Hold-Down The standard cutting surface is a porous The S135 is equipped with a high-flow vacuum system plastic sheet. Alternative cutting surfaces are to ensure optimum material hold-down for cutting. The available to optimize cutting results for any porous surface ensures evenly dispersed vacuum flow, given material or aid in controlling material no matter where you are cutting. Cutting zones may contamination concerns. Proven reliable for be designated so that cutting occurs in one area while 2,000+ hours of normal operation use. piece removal takes place in another. International Compliance Ratings Industrial Design for Rigorous Use The operating computer and control cabinet Available in a range of widths, are housed in an ergonomic enclosure that lengths and various tool head can be sealed to offer dust and water resistant Heavy-duty cable connectors protection in harsh or high particulate will be built to match your Easy access, sealed doors for inspection and environments. Additionally, cabling connectors, application needs, allowing servo motors and display components meet recognized international protection ratings Advanced electro-pneumatic regulator for precise tool pressure control Heavy-duty construction with scratch-resistant powder coated finish The series of drives is capable of Condition Based Predictive Maintenance. 779 Washington Street Buffalo, NY 14203

Flexible Design Tool Head Safety • Four remote emergency stops: two on cutting gantry, two system-mounted • Additional gantry-mounted stop disks pause system operation until returned to neutral and reset. Operation can then be resumed from any position • Tool head is equipped with plexiglass safety window to keep hands free of knife during operation • Single turn-off point with a universal power system for lockout/ tagout safeguards employees from unexpected start-up Choice of standard, heavy-duty or fiber tool head, featuring individually aligned and calibrated tool spindles with your choice...