ELECTRO PNEUMATIC TAPPING UNIT BEG 48 The BEG 48-series is a flexible electro-pneumatic unit in a modular design. The electric motor runs the spindle, while the feed is pneumatic. Hydraulic feed control makes it possible to use rapid advance and to adjust the feed rate in proportion to the pitch and the rpm. A tapping collect or a tapping spindle gives the unit the necessary length compensation. The series is available with JT2 taper or integrated ER32 chuck as well as with multi-spindle heads. • COMPACT YET FLEXIBLE DESIGN • MODULAR HYDRAULIC FEED CONTROL FOR THE WHOLE STROKE Guidlines for choice of unit TAPPING UNIT CAPACITY IN ALUMINIUM/BRASS CAPACITY IN PLASTICS Depth accuracy +/-Rapid advance rate (max.) Controlled feed rate Air consumption Sound level Min. Center to Center Spacing Single Spindle 90 mm Motor and Transmission specifications E2 does not recommend tapping with a floating holding at higher speeds than 2000 rpm. Maximum speed is lower when tapping a deep or blind hole and/or using a large thread.

Optional orientation of transmission housing (900 steps) *Front mount is not possible at BE487 with linear transducer You can download 2D CAD-drawings and 3D CAD-models on www.e2systems.com. Necessary components Accessories TAPPING ATTACHMENTS PAGE MULTI-SPINDLE HEADS Electric switches Pneumatic switches Inductive switches or Linear Transducer Controls for BEG 48-units with Electric switches Pneumatic switches Inductive switches or Linear Transducer On www.e2systems.com you can find more information as well as the same information as above in imperial units. When requesting a quote or ordering,...