Supply feed (1/11) Voltage ratings Current ratings Terminals Mounting method Description The ControlPlex® intelligent power distribution systems offer a genuine IO link device, together with the CPC10IO-S1-001 controller, for direct connection to the control technology in machine construction and process control. ControlPlex® with IO link requires only a single port on the IO link master for max. 16 ESX50D-S electronic circuit protectors. • Power distribution via SVS201-PWR power board (4, 8, 12 or 16 slots, further versions upon request) • Via the IO link interface, up to 16 plug-in type ESX50D-S100 and ESX50D-S110 circuit protectors can be controlled and parameterised by the PLC and additionally measuring values (load current etc.) can be transmitted. • A standard ESX50D slot can be used for the IO link module CPC10IO-S1-001. • The IO link bus head has been designed to the IO link standard 1.1. • The access time (16 circuit protectors) is typically only 400 ms for all cyclical process data. • Electrical connection of the IO link module is via a PTSM 0.5/ 3-P-2.5“ connector with push-in technology. Suitable for the following types: Power distribution boards SVS201-PWR-xx Electronic circuit protector ESX50D-S100 (completely parameterisable by means of the CPC10IO) Electronic circuit protector ESX50D-S110 (current rating adjustable by means of the rotary switch on the circuit protector, otherwise completely parameteris-able via the CPC10IO) • Integral DC24 V power distribution system for power distribution and overcurrent protection • Complete diagnosis and parameterising of the entire power distribution system • For electronic circuit protectors ESX50D-S100 / -S110 • Variable configuration of the connection with up to 16 electronic circuit protectors • Fully-fledged communication interface IO link via a port of the IO link master • Service and maintenance interface via IO link connection • Profitability through considerably reduced wiring time • Reduction of planning, design and installation time • Ease of maintenance, diagnosis and system extension Type CPC10 Bus terminal controller for ControlPlex® Board for SVS201-PWR-xx with ESX50D-S100 / -S110 •integral DC 24 V power distribution system • for max. 16 psc electronic circuit protectors type ESX50D-S xxx •_ communication-capable Version: Bus system IO IO link terminal: 3-pin connection sleeve Version - number of power distribution boards to be connected S1 pluggable, 1 port Product versions 001 marking version Application Intelligent DC 24 V Power Distribution System DC 24 V (18 ... 32 V) typically 15 mA IO link connection plug-in mounting on SVS201-PWR-xx IO link connection with the IO link master (X81) X81 COM connection with the IO link master via inlet plug the electrical specification has to meet the requirements of the “IO Link Community” connector 1: IO link L+ DC +24 V connector 2: IO link C/Q connector 3: IO link L- power supply must also be possible via X81 COM Terminals connectors, 3-pin (plugged on) cable cross section flexible with wire end ferrule (without plastic sleeve) 0.25 - 0.5 mm2 stripping length 6 mm Status indication of the CPC10PN-Tx LED "PWR" LED lighted with supply voltage applied. LED indication unicolour green LED “CE/CM“ display shows the status of the communication unit LED status indication options: red, green, yellow, orange Control input is via the processor of the CPC10IO.

CAUTION Caution: Electrostatically sensitive sub-assemblies can be destroyed by voltages far below the human perception threshold. These voltages already occur if you touch a component or electrical terminals of a subassembly without being electrostatically discharged. The damage of a sub-assembly caused by an overvoltage is often not immediately recognised, but will be noticed only after a longer operating time.