The wireless TcAs sensor was developed to identify symptoms of failure modes or defects in machines and equipment in general in accordance with ISO 20816. Additionally, with triaxial spectra and a contact temperature sensor, the TcAs is capable of monitoring unusual equipment and structures such as suspensions, servers, pipelines, and valves. Furthermore, the solution includes an online platform, with no need for local installation, featuring various tools that assist in data analysis and allow for constant monitoring of asset health. The loTTcAs sensor has two monitoring modes: spectral/waveform and telemetry. The configurable telemetry monitoring includes global vibration and contact temperature metrics minute by minute. In spectral monitoring, different tools can be used: spectrum, waveform (linear, circular, and orbital), frequency filters, cepstrum, spectral envelope (demodulation), autocorrelation, and multi-metrics. • One of the smallest sensors on the market • Long battery life • Easy mounting • High spectral resolution up to 91,200 spectral lines • More than 200 time and frequency based metrics, in different bands, for alert creation • Monitoring of rotating machines in general according to ISO 20816 • True simultaneous triaxial measurement • Remote sensor updating Datasheet TcAs - Version 7 - March 2026 - en - Public Document Main Applications • Motors, pumps, and fans • Machine structures: chassis, suspensions and springs, rails, etc. • Pulleys and roller bearing housing • Cardan shafts • Bearings (more advanced defects - stage 3 or 4) • Assets with lower criticality

1 - It is possible to monitor assets whose temperature exceeds 84 °C (183 °F), especially assets with intermittent characteristics and with room temperature below 24 °C (75 °F). However, Dynamox does not provide warranty in these cases. Specific condition for application outside explosive atmospheres. 2 - The application at temperatures below 0 °C(32 °F) impacts the battery autonomy. This effect worsens the lower the temperature, estimating a reduction of about 50% of useful life in applications at -20 °C (-4 °F). Specific condition for application outside explosive atmospheres. 3 - This temperature...

1 - Calculated amplitude resolution is based on the accelerometer digital output in pg/LSB or mg/LSB. 2 - Check the setting in the Spectral Monitoring Settings" table. 3 - Minimum RPM based on the longest measurement considering one full revolution of the shaft. Datasheet TcAs - Version 7 - March 2026 - en - Public Document

Quick Installation Guide Define the critical points of the machines to be monitored for the DynaLogger installation; It is only necessary to install one DynaLogger per monitoring point, because the devices are triaxial; Avoid installation in areas of the housings that present any stiffness loss. Example: cooling fins, covers, and protections. Try to install in rigid parts of the machine, preferably near the bearings; Align one of the axes of the DynaLogger with the actual axis of the machine. These axes are shown in the schematic to the side and on the body of the devices. A detailed installation...

© 2025, Dynamox® is a registered trademark. The contents of this publication are presented for information purposes only. Every care has been taken to ensure the validity of the information contained in this publication, but no liability can be assumed for any loss or damage whether direct, indirect or arising from the use of the information contained herein. We reserve the right to modify or improve the specifications of our products at any time without prior notice. Datasheet TcAs - Version 7 - March 2026 - en - Public Document