Technical Data Sheet DYMO Industrial Heat Shrinkable TubingDescription Flame retardant (3:1 shrink ratio) polyolefin sleeves used for wire identification. The identification marks are permanent immediately after printing and remain legible even when exposed to solvents, fuels and oils. The sleeves are low profile and lightweight. They may be used to provide strain relief and insulation in addition to identification. - UL Recognized as a component to UL224 (UL File Number E348356) All UL information can be found at UL.com under certifications - Meets the performance requirements of SAE-DTL-23053/5 classes 1 & 3 - Printed tubing meets mark permanence requirements of MIL-M-81531 and MIL-STD-202G before and after shrinking - To the best of our company's knowledge we declare that our products meet the most recent standards of the European Directives considering REACH and ROHS. None of the substances identified as "substance of concern" has been and will be contained in the product(s), listed on this Technical Data Sheet, to a higher level than mentioned in the European Directives considering REACH and ROHS. - Total Thickness: 0.5mm (maximum)

Technical Data Sheet - Shrink Ratio: 3:1

Technical Data Sheet Salt Water: 5% - 30 days at 45°C (113°F), 85% Relative Humidity with no visible effect on text or background - Two years stored at 21°C (69.8°F) and 50% Relative Humidity - This product is not developed to be used on humans, animals and/or in direct food contact. Skydrol is a registered trademark from Solutia

Tech hnical Data SSheet All of the de escriptive inform mation, performaance data, and recommendation r ns for the use off DYMO productts shall be used o only as a guide an nd do not reflectt the specificatio on or specificatio on range for anyy particular propperty of the prod duct. Furnishing such information n is an attempt to o assist you and in no event willl constitute a waarranty of any kiind by DYMO or DYMO distributtors. All purchasers of DYMO products shall be resp ponsible for inde ependently dete rmining the suittability of the maaterial for the pu urpose for which it is purchaseed....