Tapping Valve TOP 1014 for pipes made of ductile iron, steel or fibre cement

Tapping Valve TOP 1014 Sturdy – innovative – compact The new Düker disc tapping valve The compact tapping valve is made of ductile cast iron, with coating-optimised design and with seamless enamelling all over. Benefit from the low design and the inferior flow resistance. Use the same valve for DN 80 up to DN 300 – adaption to the pipe diameter through stainless steel clapping bands. Fully rubberised toothed disc with sophisticated sealing principle: • no residual water – maximum hygiene! • sturdy disc made of stainless steel • sealing construction insensitive to dirt and deposits • sealing protected...

Service Connection Two practice-oriented solutions TOP-FIX • connection with interior thread Rp 1 ½ “ • proven screwed connection • thread sealed on all sides • connection with turnable angle fitting • turnable 360° TOP-DREHFIX • made of ductile iron, completely enamelled • connection with assembly-friendly bayonet lock • with open/closed marking at the bayonet connection • with PushFit socket for plug-in or with assembled PE outlet for welding • reliably water-tight Outlets • TOP-FIX: DN 40, interior thread Rp 1 ½ “ •  TOP-DREHFIX: PushFit for plug-in DN 32, 40, 50, 63 or assembled PE outlet...

Stem Extension Sets GW 336 and Düker Quick Two practical options For the connection of a stem extension set as per GW 336: • proven connection of the stem extension set Stem Extension Sets GW 336 • pinning of the interior part and clicking in of the exterior tube Düker Quick The intelligent alternative: Düker Quick – restrained without pinning Thanks to an assembly-friendly quick-action coupling between the outside tube of the stem extension set and the Düker Quick, the connection is restrained in just one step. The corresponding stem extension set is available from D

Assembly and Drilling Universal for pipes DN 80 up to DN 300 • adaption to the pipe diameter with clapping bands • blue clapping bands for differentiation to the bands of other Düker tapping valves • tightening torque 30 Nm Pressure drilling without difficulties • optimised for standard tapping units • maximum diameter of the drill D = 38 mm • with open sealing disc no damaging of the sealing lips • drilling chips are flushed out reliably

FITTINGS AND VALVES DRAINAGE TECHNOLOGY GLASS LINING TECHNOLOGIES JOBBING FOUNDRY Düker GmbH & Co. KGaA Hauptstraße 39-41 D-63846 Laufach Germany Phone +49 6093 87- 560 Fax +49 6093 87-246 E-Mail: [email protected] 305318 / 05.16 Specifications subject to change without notice. Internet: www.dueker.de