Stop the Chain Reaction of Wear! Characteristics A simple inline design with highly efficient flow dynamic minimizing pressure drop. Standard SAE-12 fittings SAE-10 Built from Aluminum Alloy or Stainless Steel Small and efficient system protection Bi-directional Two core in-line unit Max. operating temperature 302° F (150 ° C) Aluminum: 3,000 psi (200 bar) Stainless: 6,000 psi (414 bar) Burst pressure Aluminum: 16,000psi (1103 bar) Stainless: 1655 bar (24,000psi) Bi-directional magnetic in-line filters for plant liquids, gases and greases Built from Aluminum Alloy or Stainless Steel, the Circuit Protection Unit CP is a small 2 core Magnom™ in-line unit. The CP has a very high pressure capability making it highly suitable for a variety of industrial and hydraulic applications. In particular it is designed to protect key components, such as pumps and valves in fluid circuits. Magnom™ magnetic filters excel at extracting abrasive ferrous particles from fluid systems thus removing the major cause of wear, performance drop, system failure or product damage Why use a Magnom technology Magnetic Filters to eradicate microscopic ferrous particles? Hydraulics Engine Protection Lubrication Oils Fuel Transmissions Ideal for critical component protection in smaller transmissions, lines and hydraulic systems including auto-motive diesel. Magnom filters can be used for various types of liquids (water, tar, oils, lubricants, coolants, cutting, fuel, hydraulic fluids and transmission), and working conditions characterized by different pressure, viscosity, temperature and flow rate. Microscopic ferrous particles damage industrial fluid systems & degrade finished products. Magnetic Filters are the solution to ferrous contamination of industrial fluids. Microscopic ferrous particles tend to be the hardest material found in industrial fluids, water or gas systems. In turn, they cause wear on softer materials in the system and this causes a chain reaction that results in larger non ferrous wear particles . By eliminating the microscopic ferrous particles, the primary cause of all subsequent wear is removed and therefore system cleanliness is greatly increas

Stop the Chain Reaction of Wear! Contacts Magnom™ core elements are comprised of an annular magnet and two innovatively formed steel plates. The steel plates direct the lubricant flow and magnetic flux through channels designed to bring all the ferrous contaminants in the lubricant within the range of the magnets. www.dropsa.com [email protected] The plates also multiply the force of the magnet increasing dramatically the capturing force of the core. Finally, the plates create a “collection zone” out of the normal flow path of the lubricant, preventing re-introduction of the contaminants into...