The diamond parting-off grinder DS750 NC 4 is an innovative production machine The diamond wire saw DS750 NC 4 is a modern diamond parting-off grinder Passage (HxW) is 120 x 435 mm, travel work area is 450 x 320 mm (X axis, Y axis) The diamond wire saw DS750 NC 4 lends itself ideally for cutting contours on conical workpieces. The ball screws used for the feed allow the pre-programmed contour to be followed with high precision. The process of programming the workpiece contour with external CAD programs is supported by such features as automatic tool radius correction, automatic closure of the contour and the graphic display and process simulation. The Diamond wire saw DS750 NC 4 cuts various substrates Hard metal green compact Thin bridges do not break out Graphite Surface in ground quality Green ceramics Complicated contours without breaks Graphite electrodes Small interior radii PP with foam Clean cut in compound materials

Key features ✓ The sawing wire is diamond-covered on all sides, allowing it to cut in any direction. V Low processing energy means minimal heating and low tension force is sufficient to clamp the workpiece. ✓ Narrow cut minimises waste and dust. ✓ Wire never jams but cuts itself free. ✓ The multiple bending of the wire means that the chip space is cleaned more effectively during each cycle than is the case with rigid tools. Tightly guided saw wire for cutting precision. ✓ No chipping, so suitable for fragile materials. The workpiece can be processed on four axes with any interpolation. The wire...