The diamond band saw BS422 A – H600 FY is a unique sawing device The diamond band saw BS422 A – H600 FY with traveling saw unit for the sawing of abrasive materials Passage (HxW) is 610 x 410 mm, cutting length (X axis) is 620 mm. The diamond band saw BS422 A – H600 FY with moving column is composed of a band unit with two deflection rollers. The diamond saw band runs over two rollers in an endless loop with the top roller being height adjustable. The cabin is protected by plexiglass. For safety reasons the machine cuts off automatically when the door is open. A variety of possibilities in cut transforms this machine into a high performance unit. Cutting can occur with water and with coolant. The diamond band saw BS422 A – H600 FY cuts various substrates Graphite Precise, even cuts Catalyser Torn bridges don’t break out Tiles The glaze does not flake off Cooling: dry Speed: 35 mm/min Cooling: water Speed: 60 mm/min Cooling: dry Speed: 900 mm/min Cooling: water Speed: 100 mm/min Aluminium oxide Clean cut, no breaking out Stainless steel coole No soldered plates tear off Plastinate Cutting surfaces on parallel planes Cooling: dry Speed: 300 mm/min Cooling: water Speed: 70 mm/min Cooling: water Speed: 2 mm/min Cooling: water Speed: 30

✓ Cut width of 0.4 to 0.8 mm (depending on saw band used) means band unit can be positioned with the help of buttons. Control: adjustable air pressure on the pressure reducer. The speed of the the servomotor (X axis). Travel and feed rates are programmable. The minimal waste. ✓ Low processing energy means minimal heating and low tension force is sufficient to clamp the workpiece. This virtually eliminates the risk of chipping when machining fragile or temperature-sensitive parts. ✓ The high band speed means high cutting performance. ✓ The quality of the cut surface is as if ground. V The Y...