The diamond band saw BS400 is available in the versions F and FY The diamond band saw BS400 is a saw with a driven column Passage (HxW) is 335 x 410 mm, cutting length (X-axis) is 750 mm. The diamond band saw BS400 in its standard version BS400 F is a machine which is X-direction driven. When equipped with an NC-driven 2-axis machine, it is available in the version BS400 FY. Serially the diamond saw is equipped with a spray protection cabin and a display. This comprises a measuring unit to measure the feed force. During cutting, the feed force is displayed on the screen. The feed and band speed can either be manually adjusted or regulated automatically according to the programmable nominal force. Both dry cutting and cutting with coolant are possible. The diamond band saw BS400 FY cuts various substrates Graphite Precise, even cuts Catalyser Torn bridges don’t break out Tiles The glaze does not flake off Cooling: dry Speed: 35 mm/min Cooling: water Speed: 60 mm/min Cooling: dry Speed: 900 mm/min Cooling: water Speed: 100 mm/min Aluminium oxide Clean cut, no breaking out Stainless steel coole No soldered plates tear off Plastinate Cutting surfaces on parallel planes Cooling: dry Speed: 300 mm/min Cooling: water Speed: 70 mm/min Cooling: water Speed: 2 mm/min Cooling: water Speed: 30 mm/min

Functioning The basic version of the BS400 F with moving column is composed of a band unit with two deflection rollers D = 420 mm with a passage (H x W) of 355 x 410 mm. The diamond saw band runs over two rollers in an endless loop. It is driven and pneumatically tensioned by the height-adjustable upper roller. The band is driven by a 2.2 KW three-phase current motor controlled by a frequency transformer. The band tension is set by the adjustable air pressure on the pressure reducer. The speed of the band can be set between 200 and 3000 m/min using the control dial. ✓ Cut width of 0.4 to 0.8...