The diamond band saw BS270 F is also available in the version FY The diamond band saw BS270 F/FY is a saw with a driven column Passage(HxW) 180× 255 mm, cutting length (X-axis) is 600 mm. The diamond band saw BS270 in its standard version 270F is a machine which is X-direction driven. When equipped with an NC-driven 2-axis machine, it is available in the version BS270 FY. Optionally the sawing forces can be used for feed regulation and shown on the display. The feed force occurring during sawing is shown on the display and feed as well as cutting speed can be manually tuned or regulated automatically in accordance with the programmable nominal force. Both dry cutting and cutting with coolant are possible. The diamond band saw BS270 F and FY are cutting various substrates Graphite Precise, even cuts Catalyser Torn bridges don’t break out Tiles The glaze does not flake off Cooling: dry Speed: 35 mm/min Cooling: water Speed: 60 mm/min Cooling: dry Speed: 900 mm/min Cooling: water Speed: 100 mm/min Aluminium oxide Clean cut, no breaking out Stainless steel coole No soldered plates tear off Plastinate Cutting surfaces on parallel planes Cooling: dry Speed: 300 mm/min Cooling: water Speed: 70 mm/min Cooling: water Speed: 2 mm/min Cooling: water Speed: 30 mm/min

Functioning The basic version of the BS270 F with moving column is composed of a band unit with two deflection rollers D = 266 mm with a passage (H x W) of 195 x 255 mm. The diamond saw band runs over two rollers in an endless loop. It is driven and pneumatically tensioned by the height-adjustable upper roller. The band is driven by a 0.75 kW three-phase current motor controlled by a frequency transformer. Key features The band tension is set by the adjustable air pressure on the pressure reducer. The speed of the band can be set between 200 and 2200 m/min using the control dial. ✓ Cut width...