DOSING CONTROLLERS DOSIERI -e PROF TECHNIK GMBH I APPLICATION The dosing controller is specially designed for the control and monitoring of dosing processes in industrial plants as well as stand-alone devices. » Automatic mode: The application-specific sequences are started and stopped by a higher-level PLC, the touch panel, digital I/O signals or even pushbuttons. The result of the dosing is reported or displayed accordingly » Semi-automatic operation: Sub-processes of the system can be started/stopped and monitored manually. This is also possible via "remote control"from a higher-level PLC » Manual operation: All actuators can be controlled and monitored manually via the touch display. Likewise, states of the sensors integrated in the system are displayed or forwarded to higher-level systems. » User account management: Users and access authorizations (can be) created, changed, copied or deleted. This data can be stored externally on a medium (e.g. USB stick) and can also be restored from there. » Two-part system architecture: control cabinet with remote operating panel » Modern user interface with graphical visualization and touch operation on a 7" display » All available motor variants are applicable (e.g. stepper motor, servo motor, » Control can also be used as Profinet master » Controller is fail-safe capable and can control or monitor assigned protected areas » Secure communication via Profisafe optionally possible » The standard communication interface to the higher-level controller is Profinet. » Clear, understandable diagnostic messages are shown directly on the display and sent as unique message numbers to the higher-level PLC. The message history can be stored externally.

DOSIER -e PROF TECHNIK GMBH DOSING CONTROLLERS DOSING SYSTEM DS03 ACCESSORIESPROFIBUS INTERFACE DS03 DP-D-004-000062 Profibus interface for remote control of the system via a Profibus slave connection (e.g. start, stop, dosing control ready, dosing control fault, greasing IO and greasing NIO). Interface for the exchange of safe signals (e.g. emergency stop...). Interface for exchange of all other signals remains Profinet (e.g. start, stop, dosing control ready, dosing control fault, IO and NIO dosing). For job selection and transfer of status signals by means of digital inlets and outlets on...