1. Catalogs
  2. DONALDSON
  3. Emissions DPF Cleaning System - Pulse Cleaner
video corpo

Emissions DPF Cleaning System - Pulse Cleaner

Emissions DPF Cleaning System - Pulse Cleaner

Emissions DPF Cleaning System - Pulse Cleaner

Product catalog summary
Overview
The Donaldson DPF Pulse Cleaner is designed for routine cleaning of diesel particulate filters (DPF) by removing ash and unburned hydrocarbons in under 15 minutes. It is suitable for truck maintenance facilities and eliminates the need for external filter cleaning services.

Features
  • Uses high-volume, low-pressure pulses to dislodge soot/ash.
  • Captures contaminants in a disposable ash receptacle.
  • Self-contained system prevents contamination of ambient air.
  • Accommodates DPFs of various sizes with available adapters.
  • Standard electrical connection and short installation time.

Specifications
  • Dimensions: 28" Width x 43" Depth x 78" Height.
  • Weight: 710 lbs.
  • Electrical: 120V, 15 amp.
  • Compressed Air: 90 PSI minimum at 4 CFM.
  • Energy Consumption: $8.00 to $24.00 annually based on usage.

Operation
  1. Remove DPF from vehicle.
  2. Place and secure DPF on lift table.
  3. Test and record DPF pressure levels before and after cleaning.
  4. Initiate pulse cleaning cycle.
  5. Re-install DPF.

Safety and Control Features
  • High Temperature Lockout: Shuts down operation if a hot filter is detected.
  • Filter Position Indicator: Ensures proper positioning before cleaning.
  • Operation Selector Switch: Allows testing and cleaning cycle activation.

Maintenance and Replacement Parts
  • Ash Receptacle (P228279): Replace when pressure reading exceeds 2" H2O.
  • Test Sleeve (P230116): Used to measure the ash receptacle's useful life.

Additional Recommendations
For extremely plugged DPFs, thermal regeneration is recommended using the Donaldson Thermal Regenerator. For more information, refer to brochure number F111182 or visit the Donaldson website.
See more

Catalog excerpts

Emissions DPF Cleaning System - Pulse Cleaner-1

Heavy-Duty Diesel Engine Diesel particulate filters (DPF) require routine cleaning to remove ash that builds up over time. Most vehicles using a DPF system will have an on-board filter service monitor to indicate the filter condition and guide your This unit is designed to clean the DPF by removing ash and unburned hydrocarbons in less than 15 minutes. It has no special power requirements and saves the on-going expense of a filter cleaning service. This system is ideal for truck maintenance

 Open the catalog to page 1
Emissions DPF Cleaning System - Pulse Cleaner-2

thai quickly and safely cle; Size, Weight and Clearance 28" Width x 43" Depth x 78" Height Clearance requirement: 4" on left side; 12" on right side for crank handle and the back side for filter Clean, dry compressed air source: Replacement Parts Ash Receptacle and Test Sleeve Finish (interior and exterior) Hi-gloss, powdered coating finish Approximate Energy Consumption No tools are required to clean a DPF in the Donaldson Pulse Cleaner (part number X009981). The unit also has numerous built-in safety mechanisms. • Uses high-volume, low-pressure pulse* to dislodge unburned soot/ash from the...

 Open the catalog to page 2
Emissions DPF Cleaning System - Pulse Cleaner-3

ans diesel particulate filters Main Diaphragm Control Panel Details below Pressure Gauge Displays in inches of water Filter Engaged Lift Table High Temperature Filter Sensor Door Interlock Retention Handle System Features | Safety Features Solenoid Valve Pressure Regulator/Switch Electrical Connection Check Valve Crank Handle Test Sleeve (diesel particulate filter position during cleaning) DPF Pulse Cleaning Steps 1. Remove the DPF from the vehicle 2. Place DPF on lifttable and secure 3. Test and record DPF pressure level 4. Initiate pulse cleaning cycle 5. Test and record DPF pressure level...

 Open the catalog to page 3
Emissions DPF Cleaning System - Pulse Cleaner-4

DPF Pulse Cleaner Replacement Parts Ash is a very fine particulate and requires care when handling. For convenience during service, use the cap included with the new ash receptacle to contain the contaminant during disposal and handling. The ash receptacle must be replaced when the life test pressure reading is above 2" H20 on the pressure gauge. The test sleeve ships with each unit, and is needed to measure the useful life of the ash receptacle. If you're considering the Donaldson Pulse Cleaner, you may also be interested in the Donaldson DPF Thermal Regenerator. DPF filters will plug over time...

 Open the catalog to page 4

All DONALDSON catalogs and technical brochures

  1. P-EGS

    3  Pages

  2. (P)-GS N

    6  Pages

  3. PLEATED BAGS

    3  Pages

  4. HPK05

    6  Pages

  5. Bulk hP

    4  Pages

  6. ULTRAPOREX SB

    2  Pages

  7. LITHOGUARD®

    2  Pages

  8. BSMmax

    2  Pages

  9. DT filter

    22  Pages

  10. Strainers

    4  Pages

  11. Valves

    6  Pages

  12. Breathers

    14  Pages

  13. TT15/30/60

    2  Pages

  14. SP100/120

    4  Pages

  15. WL16

    4  Pages

  16. W613

    4  Pages

  17. FPK02

    6  Pages

  18. HPK02

    4  Pages

  19. panel filter

    1  Page

  20. GDX

    4  Pages

  21. SYNTEQ XP M/S

    2  Pages

  22. Synteq XP

    4  Pages

  23. Ultrac? AK

    2  Pages

  24. Ultrapoly? PE

    2  Pages

  25. ULTRAC A

    2  Pages

  26. Rotary Valves

    10  Pages

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.