Band Saw Blades Bi-Metal & Carbide Blades for Metal Cutting Applications S ­ olutions For ALL Your Sawing Needs | (888) 362=5572 | www.doallsawing.com

Ordering the Right Blade The part number you will use in ordering is a combination of the catalog number and six more digits that represent the band length to three decimal places. The following examples would be used to order blade 303 133 in various band lengths: • 180 inches: 303 133180.000 • 132-1/2 inches: 303 133132.500 • 93-1/4 inches: 303 133093.250 Selecting the Optimum Blade Pitch For best results a minimum of 3 teeth and maximum of 24 teeth should be in contact with the workpiece at any given time. Determining the proper pitch is based on the length of this contact. For solids, this...

Blade Break-in Procedure Always break in a new band saw blade. The blade break-in procedure dresses and strengthens new, ultra-sharp teeth. Proper break-in can increase band life by 25 to 50 percent. Breaking in the blade • Saw at the recommended band speed. • Cut at 1/2 the normal feed rate. (Cuts should take twice as long). • Cut for 20 minutes (40 minutes for DoALL Powder Metal blades), then increase feed force in steps until you attain the normal cutting rate. To ensure penetration in very tough and work-hardening materials, you will need to apply more feed force and cut at a faster rate...

BI-METAL S CARBIDE Carbide Set Tooth Carbide-tipped set tooth design for sawing abrasive materials such as aluminum castings and composites Single Pitch Inch Metric Teeth per Inch Gage 2.5 Width Gage 3/8 0.025 305 015* 10 0.6 1/2 0.025 305 020* 13 0.6 3/4 0.035 305 025* 19 0.9 1 0.035 305 045* 27 0.9 1-1/4 0.042 305 326** 305 323 34 1.1 1-1/2 0.050 305 375** 305 423 41 1.3 2 0.063 305 523 54 1.6 * Straight Set | 2-3 ** Raker Set Triple Chip Carbide-tipped triple chip design for sawing the toughest metals Superalloys, Nickel based alloys, Titanium, Tool steels, Stainless steels Single & Multi...

THERE’S NOTHING WE CAN'T CUT... W ith more styles and sizes of saw blades available, DoALL Sawing Products can provide you with the best blade for your sawing application. Our selection of bimetal blades, tungsten carbide tipped blades, carbon steel blades and knife edge blades, plus tungsten and diamond grit edge blades, gives you the widest choice available. So no matter if you’re cutting solids or structurals, mild steels or exotic alloys, silicon, glass, wood, plastic or foam, there’s a DoALL band saw blade that’s just right for you. To help you find that best blade call "SAM", DoALL’s Solutions...