FlexxPump_125
2Pages

During the manually triggered active RUN command („quick check“/ extra dispense), the LCD displays the approximate back pressure in bar. In addition, the green LED lights up. Adjustbale setting of number of strokes c Adjustable setting of break time h Adjustabe setting of emptying time Et During the manually triggered, active FIL command, the LCD displays the approximate back pressure in bar. In addition, the green LED lights up. 5.5 PRO menu Being in operating mode hour mode -h-, you can change the break time h as well as the number of cycles c (number of strokes). Being in PRO menu the first step is to set the break time h and after-wards the number of cycles c; direct access to the number of cycles c is not possible. Running empty time mode Et, you can change the emptying time Et in months. 5.6 FIL menu This function enables you to prefill connected accessories (tubes, distributors,...) with the lubricant contained in the lubricant cartridge, especi-ally during the initial start-up of the FlexxPump 125 time. However, the process can also be aborted manually at any time. 5.7 Input and output signals - time control If the process is aborted during FIL command Clr appears at first. PIN assignment - time control 5.3 Actions with the activation and programming key (APK) 1. Remove the APK from the underside of the FlexxPump 125 time. 2. Place the APK on the action area on the front of the FlexxPump 125 time 3. Remove the APK from the action area (SET) as long as the desired menu item is displayed in the LCD. After each cycle the maximum back pressure is displayed in bar. Displayed when the cartridge is empty and needs to be replaced. output signal Type: M12x1 female connector; 4-pin; A-coded The FlexxPump 125 time can be switched off completely by switching off the supply voltage.  The output signal at PIN 4 can be tapped for further processing (e.g. indicator light or external control). The maximum permissible current output must not exceed Imax < 20mA. No inductive load (e.g. relay) may be connected! LCD high, permanent cartridge empty 0,5Hz square wave signal, permanent cartridge error 5.4 SET menu The SET menu allows you to change the operating mode and the cartridge size of the FlexxPump 125 time. You can switch between hour mode -h- and empty time mode Et. fatal error 6. Maintenance NOTICE -h- Operating mode: hour mode -hEt Operating mode: empty time mode Et 125/250 Changeable value of cartridge size If you would like to change the operating mode, move the activation and programming key back to the action area. When your desired operating mode is displayed on the LCD, remove the activation and programming key from the action area. A used lubricant cartridge must not be replaced on the FlexxPump 125 time as the integrated stroke counter of the FlexxPump 125 time is automatically reset by the cartridge sensor after a cartridge has been removed. Only use full lubricant cartridges.

This brief instruction of mounting the FlexxPump 125 time addresses to experienced users. Please visit www.dls-schmiersysteme.de to download the complete user manual including all safety instructions. 1. Product details FlexxPump 125 time 0 FlexxPump 125 time 1 LCD 2 Operation pad (for actions with the APK 3 Electric interface M12x1 4 Activation and programming key (APK) 5 Lubricant outlet / M16 male thread for bottom mounting 6 M5 female thread for bottom mounting 7 Serial number 8 M5 female thread for rear mounting 9 Cartridge sensor 10 Lubricant inlet with thread for cartridge 11...