TECHNICAL DATA SHEET PVC glue Fills openings up to 0,6 mm Bonding of rigid PVC, PVC gutters, double-paned windows, pipes in rigid PVC, fittings. Bonding of PVC pipes with exterior diameter up to 160 mm. Also suitable for ABS. TECHNICAL CHARACTERISTICS Base Synthetic resins and solvents Does not fear frost, but when stored in a cold area, viscosity increases Shelf life, in the original packing in dry conditions between +5°C - +25°C PACKING 12 cans with brush of 250 ml/box - 50 boxes/pallet METHOD OF USE Preparation All surfaces need to be dry, clean and free from dust of grease. Application • Coat an even layer of Paracol PVC PVC with a brush on both parts to be assembled with no excess. • The bond will be more complete if uniformed pressure is used. • For the bonding of PVC pipes check the proper fitting of both ends (male and female). • The two tops should be rubbed spirally with the glue and the pipes should be pushed together without any twisting. • Wipe off immediately excess of glue with a clean cloth. • Avoid handling for 10 min after assembly. Bond can be tested after 24 hours. • Make sure the packing is closed correctly after use. Not suitable for pipes under pressure. Consult the safety data sheet online: www.dl-chem.com. 21 DL Chemicals EN 14680:2006 No. DoP: MP0240003 This technical data sheet replaces all previous editions. The data on this sheet have been compiled according to the last laboratory report. Technical characteristics can be changed or adapted. We are not responsible for any incomplete information. Before use, one needs to ensure that the product is suitable for his application. Therefore, tests are necessary. Our general conditions apply. DL Chemicals nv Roterijstraat 201-203 - Zone 5 Snepbeek - 8793 Waregem - Belgium T +32 56 62 70 51 - F +32 56 60 95 68 [email protected] - www.dl-che