TECHNICAL DATA SHEET Two-component polyurethane-based adhesive Very fast strength build-up (after 2 hours already 80% of the final strength) Extremely high end strength Does not need air moisture to harden Thixotrope (does not expire) Odourless Shrink-free Solvent-free For indoor and outdoor use Water resistant after complete curing Paintable with most water- and solvent-based paints Bonding of angle irons in profiles of windows, doors and gates. Carrossery construction. Metal construction. For the structural bonding of many materials, such as plastics (PVC, acrylic, HPL, polyester...), metal, cement, wood, glass, concrete, stone, natural stone, polystyrene, polyurethane... Applications under water (if applied to dry surfaces). TECHNICAL CHARACTERISTICS Base Curing system Chemical curing (exothermal reaction) Mixing ratio Processing time (open time) Complete curing time Viscosity (mixture) Density (mixture) Shore hardness (mixture) Application temperature Temperature exothermal reaction Temperature resistance of cured product Tensile strength (*) after 48 hours of curing at 20°C Heat conduction coefficient Shelf life, unopened packing in dry conditions between +20°C +30°C (*) The values are provided only as technical information and do not constitute specifications of the product. PACKING AND COLOUR 6 x 2x200 ml (400 ml) side-by-side cartridges and 6 nozzles per box Milky METHOD OF USE Preparation • The surfaces to be bonded must be free of dust, dirt, oil or grease. • Thermoplastic materials such as PVC, polycarbonate, PMMA... can be pre-treated with isopropanol. The use of strong This technical data sheet replaces all previous editions. The data on this sheet have been compiled according to the last laboratory report. Technical characteristics can be changed or adapted. We are not responsible for any incomplete information. Before use, one needs to ensure that the product is suitable for his application. Therefore, tests are necessary. Our general conditions apply. DL Chemicals nv Roterijstraat 201-203 - Zone 5 Snepbeek - 8793 Waregem - Belgium T +32 56 62 70 51 - F +32 56 60 95 68 [email protected] - www.dl-chem

solvents should be avoided, as they can damage the surface. The pretreatment of all other surfaces can be carried out with acetone. Never use petrol or other solvents. For lacquered surfaces, perform a mechanical sanding operation to remove paint from the surface to be bonded and to increase the strength of the bonding. Allow the pre-treated surfaces to dry before applying the adhesive. Underfloor heating must have dilated at least 48 hours before installation. Application • The user must test and approve the product for the specific application required. • Check the homogeneous mixing of the...