A/120/CR Calibration Reference IEPE Accelerometer 10mV/g or 100mV/g ±10% General purpose Konic Shear IEPE accelerometer for use as a reference device in calibration or validation checks. Requiring a constant current supply. With a standard 10/32 tapped thread in the top of the accelerometer this allows back to back calibration of other accelerometers ensuring both devices operate along the same axis. Available with a range of stud adaptors to allow the connection of numerous types of accelerometer to the integral 10-32 UNF tapped hole. The A/120CR can be supplied in a range of different sensitivities to suit your requirement. Please let our sales team know the stud size and sensitivity you require when ordering. Maximum test accelerometer mass 25grams Temperature Response Options: Typical Frequency Response Typical Spectral Noise (100mV/g) Voltage/Charge Sensitivity 1.0mV/(m/s2) or 10.2mV/(m/s2) 10mV/g or 100mV/g ±10% Resonant frequency 28 kHz Typical Frequency ±5% 1Hz – 8kHz Response (unloaded) ±10% 0.7Hz – 9kHz Cross axis error ≤5% Temperature range -50/+125°C -58/+257°F Charge sensitivity -5% @ -50°C -5% @ -58°F deviation (20°C/68°F) +5%@ +125°C +5%@ +257°F Shock level 9807m/s2 1000g Base Strain Sensitivity 0.001g/µstrain Supply voltage 15/35 V DC Supply Current 2/20 mA Bias voltage 10/14 VDC Setting time to 90% final val. <3 sec Case material Titanium Mounting Base tapped hole, 10-32 UNF x Base tapped hole, 104mm deep 32 UNF x 0.16in deep Weight 24g 0.85oz Connector Case Seal Size 10-32 UNF Microdot Welded hermetic connector 14.3 (A/F) x 25mm 0.56 (A/F) x 0.98in Please note: For information and reference only. Data should not be used as pass / fail criteria for calib