Catalogs >
DIS Sensors >
QG76-SD-010H-AV-CM

QG76-SD-010H-AV-CM
2Pages

Catalog excerpts

Housing Dimensions Mounting Ingress Protection (IEC 60529) Relative humidity Weight Supply voltage Polarity protection Current consumption Operating temperature Storage temperature Measuring range Centering function Frequency response (-3dB) Accuracy Offset error Non linearity Sensitivity error Resolution Temperature coefficient Max mechanical shock Output Output load Short circuit protection Output refresh rate Stainless steel 70x60x33 mm 4x M4x25 mm stainless steel pozidrive screws (optional: 2x 04 mm positioning pins) IP67 0 - 100% ca.700 gr 8 - 30V dc Yes < 50 mA -40 .. +85°C -40 .. +85°C ± 10° Yes (2,5 V = 0°), range: ±5° 10 Hz overall 0,04° typ. < ± 0,02° typ. (< ± 0,05° max.) after centering < ± 0,04° typ. (< ± 0,09° max.) < ± 0,03% typ. (< ± 0,08% max.) 0,01° ± 0,005°/K typ. 20.000g 0,5 - 4,5 V Rload >20kO, Cload <20 nF Yes (max 10 s) 20 ms © Dewit Industrial Sensors - Oostergracht 40 - 3763 LZ SOEST - The Netherlands www.dis-sensors.com Subject to change without notice

Open the catalog to page 1

Transfer characteristic Vout = 2,5 + 2*(α/10) [V] clipping outside measuring range Measurement orientation Default 0°: horizontal, no acceleration applied. Cross tilt sensitivity error: < (0,12 * cross tilt angle)² % typ. Note: one axis <10° tilt for max. accuracy QG76-SD-010H-AV-CM Connection Wire / pin coding Output Y Supply voltage Programming interface RS232 Rx Programming interface RS232 Tx Gnd Centering input Output X Shield Mechanical dimensions Center function Centering can be done to eliminate mechanical offsets. To execute centering connect center input to ground (>0,5sec) within...

Open the catalog to page 2