Catalogs >
DIS Sensors >
QG65N-KAXYZ-8-CAN-C(F)M

QG65N-KAXYZ-8-CAN-C(F)M
2Pages

Catalog excerpts

QG65N-KAXYZ-8-CAN-C(F)M Acceleration sensor 3 axis horizontal/vertical mounting (RMS or Signed Peak value) Output CANopen Supply voltage 8 - 30V dc Measuring range _±8_g_ Dimensions (indicative) Mounting Ingress Protection (IEC 60529) Relative humidity Weight Supply voltage Polarity protection Current consumption Operating temperature Storage temperature Measuring range Centering function Frequency response (-3dB) Accuracy (2a) Offset error Non linearity Sensitivity error Resolution Temperature coefficient Max mechanical shock CAN interface (hardware) CAN communication profile Baud rate Node Id TPDO messages TPDO1 event time Sync mode Heartbeat Programming options Output format Filtering_ Boot time Reinforced plastic injection molded (Faradex DS, black, EMI shielded by stainless steel fiber in PC) 60x50x27 mm 4x M5x25 mm zinc plated pozidrive screws included (optional: 2x 04mm positioning pins) IP67 ± 8 g Yes, 2 horizontal axes only, (CANout 0 = 0 g), range: ±5° 0 - 1600 Hz Range ±1/2/4/8 g: overall 0,02/0,04/0,08/0,16 g typ. < ± 0,5 mg typ. (< ± 1,5 mg max.) after zeroing < ± 0,4% full scale 0,002 g ± 0,3 mg/K typ. 10.000 g CAN 2.0 A and B according to ISO 11898-1 & ISO 11898-2 CANopen, CiA301 V4.2.0 & EN 50325-4 125 kbit/s (default, range 50/125/250/500/1000 kbit/s) 01 h (range: 01h - 7Fh) TPDO1: 181h (for Node ID=01h) 50 ms (default, range 10-500 ms) On/off (default: off) On/off (default: on, 2s) Baudrate, Node-Id, Event time, Sync mode, Heartbeat, Output format Integer: -8000 to +8000 (PDO1:X=byte2,1;Y=byte4,3; Z=byte6,5) _High pass filter disabled. Default output mode: RMS_ < 1 s © DIS Sensors - Oostergracht 40 - 3763 LZ SOEST - The Netherlands www.dis-sensors.com Subject to change without notice

Open the catalog to page 1

CANoutput = 1000*g No clipping outside measuring range Measurement orientation The default 0 g position is when the sensor is mounted horizontal or vertical and no acceleration is applied. The axis parallel to earth gravity will indicate 1 g, the two horizontal axes will indicate 0 g. The two horizontal axes can be zeroed within ±5° tilt (by the CAN object dictionary) to eliminate mounting offsets. The axis parallel to earth gravity cannot be zero-ed. Optional the axis parallel to earth gravity can be compensated for 1 g gravity by the CAN object dictionary Output value: RMS (default) or...

Open the catalog to page 2