Catalogs >
DIS Sensors >
QG65-KI-360X-CAN-C(F)M-T

QG65-KI-360X-CAN-C(F)M-T
2Pages

Catalog excerpts

L. sensorsX-series QG65-KI-360X-CAN-C(F)M-T Inclination sensor active Temp. compensation 1 axis vertical mounting Output CANopen Supply voltage 10 - 30 V dc Measuring range 360° Dimensions (indicative) Mounting Ingress Protection (IEC 60529) Relative humidity Weight Supply voltage Polarity protection Reinforced plastic injection molded (Faradex DS, black, EMI shielded by stainless steel fiber in PC) 60x50x27 mm 4x M5x25 mm zinc plated pozidrive screws included (optional: 2x 04mm positioning pins) IP67 Current consumption Operating temperature Storage temperature Measuring range Centering function Frequency response (-3dB) Accuracy (2a) Offset error Non linearity Sensitivity error Resolution Temperature coefficient CAN interface (hardware) CAN communication profile Baud rate Node Id TPDO Event time Sync mode Heartbeat Programming options Output format Temperature compensation Filtering Modes of operation Temperature setpoint_ Boot time / Warming up time overall 0,04° typ. @ stabilized Temperature (ambient Temp. -20° .. +60°C) < ± 0,01 ° max. after centering < ± 0,03° typ. (< ± 0,05° max.) not applicable 0,001° 0°/K ( -20°C . . +60°C) _± 0,005°/K typ. (outside above specified range)_ 20.000g CAN 2.0 A and B according to ISO 11898-1 & ISO 11898-2 CANopen, CiA301 V4.2.0 & EN 50325-4 + Device Profile CiA410 DSP 2.0.0 50, 125 (default), 250, 500, 1000 kbit/s 01 h (range: 01h - 7Fh) TPDO2: 281h (for Node ID=01h), TPDO1: 181h (for Node ID=01h) TPDO1: 10 - 500 ms (default: 100 ms) On/off (default: off) On/off (default: on, 2 sec.) Baudrate, Node Id, Event time, Sync mode, Heartbeat, Output format, Temp. setpoint Sensor Temp. (PDO1 :byte 2,1), Angle: -179.999 to 180.000 (PDO2:byte 4,3,2,1) Yes, active Temperature compensation Input filter enabled, output filter disabled Event mode, Sync-mode _60°C (range 0°C - 7q°C), heating only_ < 1 s / 10min @ -10°C & 24 V © DIS Sensors - Oostergracht 40 - 3763 LZ SOEST - The Netherlands www.dis-sensors.com Subject to change without notice

Open the catalog to page 1

Measurement orientation Rotation in vertical plane. Lateral tilt sensitivity error: < ± 0,03°/° lateral tilt (typ.) Max. lateral tilt: 45° Drawn in the default 0° position. Connectivity (length ±10%) Connection Male only or Male & Female (internal T-junction) M12 connector (5 pins, A-coding) ( CiA303 V1.8.0 ) (Brass Nickel coated, contacts copper alloy) No bus termination inside. A CANbus always has to be terminated properly. For bus termination order seperate M12 termination resistor (optional: T-connector) Pin 1: Shield Pin 2: Vcc Pin 3: Gnd & CAN_GND Pin 4: CAN_H Pin 5: CAN_L Mechanical...

Open the catalog to page 2