Catalogs >
DIS Sensors >
QG65-KD-090H-AV-CM

QG65-KD-090H-AV-CM
2Pages

Catalog excerpts

Housing Dimensions (indicative) Mounting Ingress Protection (IEC 60529) Relative humidity Weight Supply voltage Polarity protection Current consumption Operating temperature Storage temperature Measuring range Centering function Frequency response (-3dB) Accuracy (2a) Offset error Non linearity Sensitivity error Resolution Temperature coefficient Max mechanical shock Output Output load Short circuit protection Output refresh rate Reinforced plastic injection molded (Faradex DS, black, EMI shielded by stainless steel fiber in PC) 60x50x27 mm 4x M5x25 mm zinc plated pozidrive screws included (optional: 2x 04mm positioning pins) IP67 0 - 100% ca 110 gr 8 - 30V dc Yes < 25 mA -40 .. +85°C -40 .. +85°C ± 90° Yes (2,5 V = 0°), range: ±5° 10 Hz overall 0,09° typ. (-45°...+45°) < ± 0,03° typ. (< ± 0,08° max.) after centering < ± 0,08° typ. (< ± 0,19° max.) (-45°..+45°) < ± 0,03% typ. (< ± 0,08% max.) 0,01° ± 0,005°/K typ. 20.000g 0,5 - 4,5 V Rload >20kO, Cload <20 nF Yes (max 10 s) 20 ms © DIS Sensors - Oostergracht 40 - 3763 LZ SOEST - The Netherlands www.dis-sensors.com Subject to change without notic

Open the catalog to page 1

QG series Transfer characteristic Vout = 2,5 + 2*(α/90) [V] No clipping outside measuring range Measurement orientation Default 0°: horizontal, no acceleration applied. Cross tilt sensitivity error: < (0,12 * cross tilt angle)² % typ. Note: one axis <10° tilt for max. accuracy Note: only one axis may exceed 45° tilt Connectivity (length ±10%) Connection Wire / pin coding Mechanical dimensions (indicative only) Output Y Supply voltage Programming interface RS232 Rx Programming interface RS232 Tx Gnd Centering input Output X Shield Center function Centering can be done to eliminate mechanical...

Open the catalog to page 2