Catalogs >
DIS Sensors >
QG65-KD-010H-AV-CM

QG65-KD-010H-AV-CM
2Pages

Catalog excerpts

L. sensorsQG65 analog series_ QG65-KD-010H-AV-CM Inclination sensor 2 axis horizontal mounting Programmable device Output: 0,5 - 4,5 V Measuring range programmable between ±1° and ±30° Measuring range Factory defaults: ±10° Dimensions (indicative) Mounting Ingress Protection (IEC 60529) Relative humidity Weight Supply voltage Polarity protection Current consumption Operating temperature Storage temperature Measuring range Centering function Frequency response (-3dB) Accuracy (2o) Offset error Non linearity Sensitivity error Resolution Temperature coefficient Max mechanical shock Output Output load Short circuit protection Output refresh rate Programming options Reinforced plastic injection molded (Faradex DS, black, EMI shielded by stainless steel fiber in PC) 60x50x27 mm 4x M5x25 mm zinc plated pozidrive screws included (optional: 2x 04mm positioning pins) IP67 0 - 100% approx. 110 gram 8 - 30V dc Yes < 25 mA -40 .. +85 °C -40 .. +85 °C Factory defaults: ±10° Yes (2,5 V = 0°), range: ±5° 0 - 10 Hz overall 0,04° typ. < ± 0,02° typ. (< ± 0,05° max.) after centering < ± 0,04° typ. (< ± 0,09° max.) not applicable 0,01° ± 0,005°/K typ. 20.000g 0,5 - 4,5 V Rload >20kO, Cload <20 nF Yes (max 10 s) 20 ms by optional QG65-configurator (measuring range, filtering) © DIS Sensors - Oostergracht 40 - 3763 LZ SOEST - The Netherlands www.dis-sensors.com Subject to change without notice

Open the catalog to page 1

Uout = 2,5 + 2*(α/10) [V] clipping outside measuring range Measurement orientation Default 0°: horizontal (label upwards), no acceleration applied. Cross tilt sensitivity error: < (0,12 * cross tilt angle)² % typ. → one axis <10° tilt for max. accuracy Connectivity (length ±10%) Connection Wire / pin coding M12 male 8p connector (Brass Nickel coated, contacts copper alloy) Pin 1: Pin 2: Pin 3: Pin 4: Pin 5: Pin 6: Pin 7: Pin 8: Output Y Supply voltage Programming interface RS232 Rx Programming interface RS232 Tx Gnd Centering input Output X Not connected Mechanical dimensions (indicative...

Open the catalog to page 2