Catalogs >
DIS Sensors >
QG65-KD-010..060H-ASP-CM

QG65-KD-010..060H-ASP-CM
2Pages

Catalog excerpts

QG65-KD-010..060H-ASP-CM Tilt switch programmable 2 axis horizontal mounting Output PNP Supply voltage 8 - 30V dc Measuring range Switch points _up to ± 60°_ Plastic injection molded housing (Faradex DS, black, EMI shielded by stainless steel fiber in PC) 60x50x27 mm 4x M5x25 mm zinc plated steel pozidrive screws included (optional: 2x 04mm positioning pins) IP67 -40 .. +85°C Switch points _up to ± 60°_ Yes (0°), range: ±5° 0,5 Hz < ±0,29° (-45°..+45°) < ± 0,01 ° (after zeroing) not applicable not applicable 0,01° ± 0,005°/K typ. 20.000g dual PNP 100 mA cont., 250 mA max 10 sec., Resistive No < 10 ms © Dewit Industrial Sensors - Oostergracht 40 - 3763 LZ SOEST - The Netherlands www.dis-sensors.com Subject to change without notice

Open the catalog to page 1

QG65-KD-010..060H -ASP-CM PNP-output: - Programmable switchpoints ±S (opt. QG65 Configurator RS232) Factory default: S = ± 15° - at 0°: safe area, conducting - outside ±S: unsafe, non-conducting - Unpowered sensor: non-conducting - hysteresis : 0,2° - safe ► unsafe delay : 500 mS - unsafe ► safe delay : 1000 mS QG65-KD-010..060H -ASP-CM The default 0° position is when the sensor is mounted horizontally and no acceleration is applied. Note: only one axis may exceed 45° tilt QG65-KD-010..060H -ASP-CM QG65-KD-010..060H -ASP-CM Zeroing should be done within 1 min. after power up. After zeroing...

Open the catalog to page 2