Catalogs >
DIS Sensors >
QG65-KD-001..025H-ASP-CM

QG65-KD-001..025H-ASP-CM
2Pages

Catalog excerpts

QG65-KD-001..025H-ASP-CM Tilt switch programmable 2 axis horizontal mounting Output PNP Supply voltage 8 - 30V dc Measuring range Switch points _up to ± 25°_ Dimensions (indicative) Mounting Ingress Protection (IEC 60529) Relative humidity Weight Supply voltage Polarity protection Current consumption Operating temperature Storage temperature Measuring range Centering function Frequency response (-3dB) Accuracy (2o) Offset error Non linearity Sensitivity error Resolution Temperature coefficient Max mechanical shock Output Output load Short circuit protection Boot time Reinforced plastic injection molded (Faradex DS, black, EMI shielded by stainless steel fiber in PC) 60x50x27 mm 4x M5x25 mm zinc plated pozidrive screws included (optional: 2x 04mm positioning pins) IP67 0 - 100% approx. 110 gram 8 - 30V dc -40 .. +85 °C Switch points _up to ± 25°_ Yes (0°), range: ±5° 0,5 Hz < ±0,1° < ± 0,01 ° (after zeroing) not applicable not applicable 0,01° ± 0,005°/K typ. 20.000g dual PNP 100 mA cont., 250 mA max 10 sec., Resistive No < 10 ms © DIS Sensors - Oostergracht 40 - 3763 LZ SOEST - The Netherlands www.dis-sensors.com Subject to change without notice

Open the catalog to page 1

PNP-output: - Programmable switchpoints ±S (opt. QG65 Configurator RS232) Factory default: S = ± 15° - at 0°: safe area, conducting - outside ±S: unsafe, non-conducting - Unpowered sensor: non-conducting - hysteresis : 0,2° - safe ► unsafe delay : 500 mS - unsafe ► safe delay : 1000 mS Measurement orientation The default 0° position is when the sensor is mounted horizontally (label upwards) and no acceleration is applied. Connectivity (length ±10%) Connection Wire / pin coding M12 male 8p connector (Brass Nickel coated, contacts copper alloy) Pin 1: Pin 2: Pin 3: Pin 4: Pin 5: Pin 6: Pin 7:...

Open the catalog to page 2