QG40N-KIXv-360-AI-CM-UL
3Pages

{{requestButtons}}

Catalog excerpts

QG40N-KIXv-360-AI-CM-UL - 1

QG40N-KIXv-360-AI-CM-UL Inclination sensor 1 axis vertical mounting Programmable device Output: 4 - 20 mA Measuring range programmable between 1° and 360° Measuring range Factory defaul: 360° Dimensions (indicative) Mounting Ingress Protection (IEC 60529) Relative humidity Weight Supply voltage Polarity protection Current consumption Operating temperature Storage temperature Measuring range Centering function Frequency response (-3dB) Accuracy (2a) Offset error Non linearity Sensitivity error Resolution Temperature coefficient Max mechanical shock Output Output load Short circuit protection Output refresh rate Programming options Plastic injection molded housing (Arnite T06 202 PBT black) 40x40x25 mm 2x M3x25 mm zinc plated steel pozidrive screws included IP67 0 - 100% approx. 45 gram 10 - 30 V dc Yes < 30 mA ( excluding output signal ) -40 .. +85 °C -40 .. +85 °C Factory defaul: 360° Yes (12 mA = 0°), range 360° 0 - 10 Hz overall 0,5° typ. < ± 0,3° ( after centering ) < ± 0,4° not applicable 0,1° ± 0,04°/K typ. 10.000 g 4 - 20 mA Rload < (50*Vs-300) [Q] (Eg: Vs = 24 V: Rload < 900 Q) Yes (max 10 s) 20 ms by optional QG40N-configurator (measuring range, filtering) © DIS Sensors - Oostergracht 40 - 3763 LZ SOEST - The Netherlands www.dis-sensors.com Subject to change without notice

Open the catalog to page 1
QG40N-KIXv-360-AI-CM-UL - 2

Iout = 12 + 8*(α/180) [mA] Centering: eliminate mech. offsets Connect center input to ground (>0,5sec) within 1 min. after power up. Normally the center input should be left unconnected. Measurement orientation Rotation in vertical plane. Lateral tilt sensitivity error: < ± 0,03°/° lateral tilt (typ.) Max. lateral tilt: 45° Connectivity (length ±10%) Connection M12 5p male connector (Glass fibre reinforced grade, contacts CuZn pre-nickeled galv. Au) Pin 1: Pin 2: Pin 3: Pin 4: Pin 5: + Supply Voltage for factory use only Gnd output centering Brown: White: Blue: Black: Green/yellow: '+...

Open the catalog to page 2
QG40N-KIXv-360-AI-CM-UL - 3

QG series Intended use, UL, Remarks QG series sensors are intended to measure inclination/acceleration/tilt. Flawless function (acc. spec.) is ensured only when used within specifications. This device is not a safety component acc. to EU Machine Directive (ISO13849). For full redundancy two devices can be used. Modifications or non-approved use will result in loss of warranty and void any claims against the manufacturer. UL File number: E312057. UL & c-UL listed product (UL508 standards UL60947-5-2 & CSA-C22,2 No.14) Product Identity / Category Code Number (CCN): Industrial Control...

Open the catalog to page 3

All DIS Sensors catalogs and technical brochures

  1. 5p, female

    2 Pages

  2. 5p, male

    2 Pages

Archived catalogs