QG40N-KDXYh-080-ASN-CM-UL
3Pages

{{requestButtons}}

Catalog excerpts

QG40N-KDXYh-080-ASN-CM-UL - 1

L. sensorsQG40N-series QG40N-KDXYh-080-ASN-CM-UL Tilt switch 2 axis horizontal mounting Programmable device Output: NPN Switch points programmable between ±1° and ±80° Measuring range Factory defaults: ±80° Dimensions (indicative) Mounting Ingress Protection (IEC 60529) Relative humidity Weight Supply voltage Polarity protection Current consumption Operating temperature Storage temperature Measuring range Centering function Frequency response (-3dB) Accuracy (2o) Offset error Non linearity Sensitivity error Resolution Temperature coefficient Max mechanical shock Output Output load Short circuit protection Boot time Programming options Plastic injection molded housing (Arnite T06 202 PBT black) 40x40x25 mm 2x M3x25 mm zinc plated steel pozidrive screws included IP67 0 - 100% approx. 45 gram 8 - 30V dc Yes < 25 mA -40 .. +85 °C -40 .. +85 °C Factory defaults: ±80° Yes (0°), range: ±5° 0-0,5 Hz ±0,5° 0° (after zeroing) not applicable not applicable 0,1° ± 0,04°/K typ. 10.000 g dual NPN 150 mA cont., 250 mA max 10 sec., protected against back EMF Yes (max 10 s) < 100 ms by optional QG40N-configurator (switch points, delay times, filtering) © DIS Sensors - Oostergracht 40 - 3763 LZ SOEST - The Netherlands www.dis-sensors.com Subject to change without notice

Open the catalog to page 1
QG40N-KDXYh-080-ASN-CM-UL - 2

NPN-output: - Programmable switchpoints - at 0°: operation zone, conducting - critical zone: non-conducting - Unpowered sensor: non-conducting Factory defaults: - output X & output Y: ±80° - hysteresis : 0,5° - operation ► critical delay : 0,5 s - critical ► operation delay : 1 s Zeroing: eliminate mech. offsets Connect zeroingr input to ground (>0,5sec) within 1 min. after power up. Normally the zeroing input should be left unconnected. The default 0° position is when the sensor is mounted horizontally (round nose upwards) and no acceleration is applied. ^ only one axis may exceed 45° tilt...

Open the catalog to page 2
QG40N-KDXYh-080-ASN-CM-UL - 3

QG series Mechanical dimensions (indicative only) Intended use, UL, Remarks QG series sensors are intended to measure inclination, acceleration or tilt angle after installing in machines, equipment and systems. Flawless function in accordance with the specifications is ensured only when the device is used within its specifications. This device is not a safety component according to the EU Machine Directive (ISO13849). For full redundancy two devices can be used in the application. Modifications or non-approved use are not permitted and will result in loss of warranty and void any claims...

Open the catalog to page 3

All DIS Sensors catalogs and technical brochures

  1. 5p, female

    2 Pages

  2. 5p, male

    2 Pages

Archived catalogs