Catalogs >
DIS Sensors >
QG40N-KAXYh-1,5-AI-CM-UL

QG40N-KAXYh-1,5-AI-CM-UL
3Pages

Catalog excerpts

QG40N-KAXYh-1,5-AI-CM-UL Acceleration sensor 2 axis horizontal mounting Programmable device Output: 4 - 20 mA Measuring range programmable between 0,1 g and 16 g Measuring range Factory defaults: ± 1,5 g Dimensions (indicative) Mounting Ingress Protection (IEC 60529) Relative humidity Weight Supply voltage Polarity protection Current consumption Operating temperature Storage temperature Measuring range Centering function Frequency response (-3dB) Accuracy (2o) Offset error Non linearity Sensitivity error Resolution Temperature coefficient Max mechanical shock Output Output load Short circuit protection Output refresh rate Programming options Plastic injection molded housing (Arnite T06 202 PBT black) 40x40x25 mm 2x M3x25 mm zinc plated steel pozidrive screws included IP67 0 - 100% approx. 45 gram 10 - 30 V dc Yes < 15 mA ( excluding output signal ) -40 .. +85 °C -40 .. +85 °C Factory defaults: ± 1,5 g Yes (12 mA = 0 G), range: ±5° 0 - 50 Hz overall 0,04 g typ. < ± 0,3% F.S. (after zeroing) < ± 0,3% F.S. < ± 1 % 0,002 g ± 0,5 mg/K typ. 10.000 g 4 - 20 mA Rload < (50*Vs-300) [Q] (Eg: Vs = 24 V: Rload < 900 Q) Yes (max 10 s) 3 ms by optional QG40N-configurator (measuring range, filtering) © DIS Sensors - Oostergracht 40 - 3763 LZ SOEST - The Netherlands www.dis-sensors.com Subject to change without notice

Open the catalog to page 1

Iout = 12 + 5,33*g [mA] clipping outside measuring range Zeroing: eliminate mech. offsets Connect zeroing input to ground (>0,5sec) within 1 min. after power up. Normally the zeroing input should be left unconnected. Measurement orientation 0 g when no acceleration applied Horizontal mounting: 1-axis or 2-axis usage Connect output-X and/or output-Y according the plot at the right. Upside down mounting possible (sensor-nose down) Connectivity (length ±10%) Connection Wire / pin coding M12 5p male connector (Glass fibre reinforced grade, contacts CuZn pre-nickeled galv. Au) Pin 1: + Supply...

Open the catalog to page 2

QG series Intended use, UL, Remarks QG series sensors are intended to measure inclination/acceleration/tilt. Flawless function (acc. spec.) is ensured only when used within specifications. This device is not a safety component acc. to EU Machine Directive (ISO13849). For full redundancy two devices can be used. Modifications or non-approved use will result in loss of warranty and void any claims against the manufacturer. UL File number: E312057. UL & c-UL listed product (UL508 standards UL60947-5-2 & CSA-C22,2 No.14) Product Identity / Category Code Number (CCN): Industrial Control...

Open the catalog to page 3