Catalogs >
DIS Sensors >
QG40-KD-090H-AV-CM-UL

QG40-KD-090H-AV-CM-UL
3Pages

Catalog excerpts

L. sensorsH-series (for demanding applications) QG40-KD-090H-AV-CM-UL Inclination sensor 2-axis horizontal mounting 1-axis horizontal/vertical mounting Output 0,5 - 4,5 V Supply voltage 10 - 30 V dc Measuring range ± 90° Dimensions (indicative) Mounting Ingress Protection (IEC 60529) Relative humidity Weight Supply voltage Polarity protection Current consumption Operating temperature Storage temperature Measuring range Centering function Frequency response (-3dB) Accuracy (2o) Offset error Non linearity Sensitivity error Resolution Temperature coefficient Max mechanical shock Output Output load Short circuit protection Repeatability Plastic injection molded housing (Quadro40, PBTP black) 40x40x25 mm 2x M3x25 mm zinc plated steel pozidrive screws included IP67 0 - 100% approx. 45 gram 10 - 30 V dc Yes < 30 mA -40 .. +85 °C -40 .. +85 °C ± 90° No 0 - 18 Hz (±10 Hz) overall 0,9° typ. (offset excluded) (-45°..+45°) < ± 1° typ. (< ± 3° max.) < ± 0,6° (-45°...+45°) < ± 2% typ. (< ± 3.5% max.) 0,01° ± 0,01°/K typ 20.000g 0,5 - 4,5 V Rload >20kO, Cload <20 nF Yes (max 10 s) 0,1° © DIS Sensors - Oostergracht 40 - 3763 LZ SOEST - The Netherlands www.dis-sensors.com Subject to change without notice

Open the catalog to page 1

QG40-KD-090H-AV-CM-UL L. sensors 0° positions drawn in plot at the right. Horizontal mounting: 1-axis or 2-axis usage Connect output-X and/or output-Y according the plot at the right. In case of 2-axis usage: Tilting one axis will influence the other axis, significant influence (10%) when > 25°. Upside down mounting possible (sensor-nose down) Vertical mounting: 1-axis usage only Connect output-X and/or output-Y according the plot at the right. Connector down: Y-output not valid Mounting with M12 to top possible Connector side: X-output not valid Mounting with M12 to left possible M12 5p...

Open the catalog to page 2

QG series Mechanical dimensions (indicative only) Intended use, UL, Remarks QG series sensors are intended to measure inclination, acceleration or tilt angle after installing in machines, equipment and systems. Flawless function in accordance with the specifications is ensured only when the device is used within its specifications. This device is not a safety component according to the EU Machine Directive (ISO13849). For full redundancy two devices can be used in the application. Modifications or non-approved use are not permitted and will result in loss of warranty and void any claims...

Open the catalog to page 3