The vane has of 150mm in height and a turning diameter in the cups of approximately 130mm. Inside it has a toothed wheel for use with an electronic photo-switch and in this way to achieve trains of pulses, which after processing will indicate the wind speed. The electronic control card must be powered by a 12Vdc source and the data is sent by possible means of communication: CANBus (standard In addition, it has a heating resistance, to increase the temperature inside, in the event that the ambient temperature is below 0°. This resistance reacts and acts. TECHNICAL CHARACTERISTICS. • Supply voltage: 100-240Vac / 50Hz-60Hz (Optional 48Vac and 24 Vac / Vdc) • Output to Speed Relay 1 and Speed 2 (programmable): o Maximum effective voltage: 250Vef o Maximum effective current: 6A. • Note: These outputs must attack a resistive type load, or loads with little capacitive or inductive effect. • Maximum wind speed: 200km / h • Interface: 8 Digits Alphanumeric LCD Display, 4 LED's status indicators and 4 push buttons for programming. _Dinaksa Pesaje Industrial S.L.U. reserves the right to change these specifications without notice www.dinaksa.com [email protected]