PRESS SOLUTIONS Get the best out of your presses www.dimeco.com

PRESS MONITOR AND ELECTRONIC CAM Stop the press immediately when a fault is detected SAFELY MAKE YOUR PRESS AUTONOMOUS - Avoid costly maintenance operations and save time - Self teaching mode - Make your production completely safe - Easy to use - Clear indications with LED’s - Just two buttons PSP 30 V2 - 2 inputs - Choose the position : either ejection or static - Counts data on both inputs - Compatible with any kind of sensors 10 30 V PNP or NPN or dry contact - Dimension : H90mm/L190 mm/D180 mm - Reference : 19444030 PSP 8C V2 - 8 cams - 4 cam lobes - 50 programs - Resetting of the encoder...

IDEAL TO CONTROL THE POSITION OF THE STRIP CHARACTERISTICS - Check the position of a pilot hole on the strip - Excellent repeatability - Can be integrated in the tool - A led indicates the status change - Adjustable sensitivity INFRARED FORKSENSORS DON'T FORGET TO ORDER A CABLE TO PLUG IN YOUR FRAME OR FORKSENSOR

PERFECT FOR CHECKING THE EJECTION OF A METALLIC PART OUT OFTHETOOL - Does not detect oil or water! PERFECT FOR DETECTING A PART INSIDE A TOOL OR OFTEN USED AS A STOP - Relatively short range PERFECT FOR DETECTING A LARGE PART IN A CHUTE - Much larger range INDUCTIVE RINGS DIMECO [email protected]

MONITORING OVERLOAD Tonnage indicator/overload detector PERFECT FOR SINGLE CRANK PRESSES MAKE YOUR PRODUCTIONS SAFER! STOP THE PRESS AT THE FIRST OVERLOAD. IMCO ONE DIAL - 1 digital dial displaying the value in tons - 1 potentiometer enabling you to select the maximum value for the tool installed on the press - Device delivered with 2 normal sensors (sensor type 112) : reference 49553617 - Device delivered with 2 sensitive sensors (sensor type G112) : reference 49553117 - Display of the tonnage used by the press - Enables you to install tools with the right power for the press - Enables you to...

NEW SELBERcontrol the bottom dead center to the micron, for high speed presses MAKEYOUR PRODUCTION SAFER ! STOP IT IMMEDIATELY IN CASE OF : - Presence of scraps - Breaking of a punch - Shavings coming back up - For cutting and stamping parts in the electronic industry (connectors and mobile phones) - Prevent you from recoiling a strip with marks on it or with crashed shavings before overmoulding it - Self teaching mode - For speed up to 2000 SPM - Turnkey and comprehensive system - Free loan (subject to availability). AVOID COSTLY MAINTEANCE OPERATION AND SAVE TIME RB- RX model, this equipment...

OPERATING PRINCIPLE By self-teaching the distance between the stripper and the lower die shoe of the tool is recorded after the first cycle. The tolerance is defined by the operator. As soon as a measure is superior to the tolerance, the press is stopped. FONCTIONNEMENT NORMAL NORMALLY OPERATING Semelle supérieure NOT OPERATING NORMALLY FONCTIONNEMENT ANORMAL Fixing Équerre bracket de détection Partie supérieureholdermatrice Punch de la Dévetisseur Stripper Die de la Partie basseplate matrice Lower die shoe Semelle inférieure Détection Shavings de copeaux detection Détection Shavings de copeaux...

Graphisme Dimeco - Impression SIMON GRAPHIC 600ex. - Janvier 2017 V2 Tool changeover system for LEAN MANUFACTURING Tools, moulds and coils handling Press feeding, oilers and conveyors