Model 36 Finger Brake
10Pages

DiAcro METAL FABRICATION EQUIPMENT 12430 55th St N Oak Park Heights, MN 55082 P - 651-342-1756 F - 651-342-1293

SAFETY INFORMATION PG. 3 ANGLE ADJUSTMENT PG. 4 MICROMETER BACKGAUGE PG. 5 #36 FINGER BRAKE BREAKDOWN AND PARTS LIST PG. 6-8 MICROMETER BACK GAUGE PG. 8 OPTIONAL STAND PG. 9

Before brake is set up for operation, mount on work bench or stand. Ensure the base is flush with the front edge of the stand or work bench, and bolt in place and secure stand to the floor. *IF BRAKE IS MOUNTED ON ITS OWN STAND, SECURE STAND TO FLOOR.

To adjust Brake for bending clearance, raise folding blade 90 degrees, insert material between edges of folding blade and leading edge of fingers (for heavy material, clearance should be twice the thickness, less for lighter gauge or if sharper bend is desired). Adjust finger mount weldment by turning arm adjustment bolts (item 48). To adjust clamping pressure, insert material under fingers and turn arm adjustment bolts until material is held securely when fingers are lowered. To adjust degree of bend, pins (item 44) located on both ends of folding blade for desired degree of bend. Remove...

MICROMETER BACK GAUGE ASSEMBLY - #8348144-170 Typically the back gauge is assembled when the finger brake is shipped from the factory. Occasionally it is removed for ease of palletizing. To install and/or zero the gauge follow the instructions below. 1. Install Quik-Set rod (item 82) in holes located in rear of the base casting. 2. Set Quik-Set nut assembly (items 79, 80 and 83) on zero and screw rods in until gage (item 78) lines up with folding blade. Quik set rods can be locked in place by tightening screws located behind folding blade. 3. To position micrometer back gauge rapidly, turn...

PARTS LIST

PARTS LIST - CONTINUED

Stand Dimensions: 48” WIDE, 15” DEEP, 33-1/4” HIGH Fasteners needed to attach Finger Brake to stand are the following: (Fasteners to attach stand to floor are not included.)

Defective parts, of a product manufactured by DI-ACRO, will be replaced or repaired at no charge for twelve (12) months following delivery to the original purchaser. Labor is included for the first 90 days. This warranty becomes void when products have not been used according to instructions furnished by DI-ACRO, nor does it cover any altered parts or unauthorized repairs. We cannot be responsible for the cost of repairs made or attempted outside of our factory. All other warranty claims are made FOB our plant, providing such items(s) is returned freight prepaid to our plant for...