Model 2 Rod Parter
9Pages

#2 ROD PARTER OPERATION AND PARTS MANUAL Aero 12430 55th St N ■ Oak Park Heights, MN 55082 Phone: 651.342.1756 ■ Fax: 651.342.1293 Email: infb@diacro.com

SAFETY INFORMATION MAINTENANCE TECHNICAL DATA SET-UP PROCEDURE REMOVING AND SHARPENING CUTTING HEADS #2 ROD PARTER BREAKDOWN AND PARTS LIST EJECT-O-MATIC GAUGE PARTS LIST OPTIONAL STAND WARRANTY

Before Rod Parter is set up for operation, mount on work bench or stand. *IF ROD PARTER IS MOUNTED ON ITS OWN STAND, SECURE STAND TO FLOOR. Apply grease to fitting in Center Stud Bolt periodically. TECHNICAL DATA There are nine holes in the cutting dies of the #2 Rod Parter from 1/8” to 5/8” in diameter, in 1/16” increments. All holes are approximately .005” oversize to allow for material clearance. Cutting heads of alloy tool steel, properly hardened and precision ground assure a high degree of accuracy and are reversible to offer double service. They are easily removed for...

SET-UP PROCEDURE After Rod Parter is bolted to work bench or stand attach Handle to Handle Holder. Install gauge Rod to Base and attach Eject-o-matic Gauge as follows: Set Gauge Arm so bolt lines up with Pivot Bolt of Rod Parter, then adjust gauge for desired hole size and length of piece. Only the lower portion of the rod should contact the gauge. OPTIONAL ACCESSORIES Cutting dies for “parting-off” square, rectangular, hexagon and other special shaped bar stock are available, call to request a special quotation REMOVING AND SHARPENING CUTTING DIES The cutting dies on the Rod Parter are...

#2 ROD PARTER PARTS BREAKDOWN PARTS LIST

EJECT-O-MATIC GAUGE Greatly increases production output as it allows the three separate operations of gauging, parting and ejecting to be obtained in a single working cycle. The Eject-O-Matic Gauge is especially valuable when cutting lengths under six inches but is equally as useful “parting” stock of longer lengths. It is supplied as standard equipment on the hand operated rod parter.

Part Number: 8230110-900 Stand Dimensions: 20” WIDE, 15” DEEP, 33-1/4” HIGH CALL DI-ACRO FOR PRICE AND AVAILABILITY Fasteners needed to attach Rod Parter to the stand are the following: (Fasteners to attach stand to floor are not included.)

Defective parts, of a product manufactured by DI-ACRO, will be replaced or repaired at no charge for twelve (12) months following delivery to the original purchaser. Labor is included for the first 90 days. This warranty becomes void when products have not been used according to instructions furnished by DI-ACRO, nor does it cover any altered parts or unauthorized repairs. We cannot be responsible for the cost of repairs made or attempted outside of our factory. All other warranty claims are made FOB our plant, providing such items(s) is returned freight prepaid to our plant for...