Model 12 Slip Roller
11Pages

SAFETY INFORMATION PG. 3 TECHNICAL DATA PG. 3 FORMING CIRCLES PG. 4 SHAPING METAL PG. 5 #12 SLIP ROLLER BREAKDOWN AND PARTS LIST PG. 6-9 OPTIONAL STAND PG. 10

Before roller is set up for operation, mount on work bench or stand*. *IF ROLLER IS MOUNTED ON ITS OWN STAND, SECURE STAND TO FLOOR TECHNICAL DATA SET-UP INSTRUCTIONS FRONT AND REAR ADJUSTMENT SCREWS The four adjusting screws (two located in the front and two located in the rear) have been built into the left and right side frames. The two front adjusting screws enable the operator to raise or lower the pinch roll, so that the correct gap between the upper and lower pinch roll may be obtained to feed the desire stock into the machine. The left and right rear adjusting screws assist the...

HOW TO FORM CIRCLES IN JUST TWO PASSES. LENGTH OF MATERIAL-necessary to form the desired size circle is the first consideration in circle forming. To determine approximate length of material needed-use the formula C=K D. C is circumference. If EQUALS 3.1417. D is diameter. For example, to find the length of material needed (C or Circumference) to form a circle 4” in diameter multiply 3.1417 by 4". Result-12.5667 is the circumference or approximate length of material needed. Cut a few pieces of material to this length for test forming. Material may have to be lengthened or...

TO REMOVE THE FORMED PART-lift clamp handle and slide the support lever handle to the right. The upper pinch roll will rise. Slide the material off roll. If the material is not long enough or if the formed part is not the proper diameter, additional samples will have to be made. Thousands of identical parts can be precisely duplicated when proper adjustments of the roller have been made. BENDS CAN BE LOCATED AT ANY POINT IN METAL TO OPERATE-insert material to be formed from the rear of the machine. Material should be inserted in the machine so that the rolls just “nip” the end of the...

#12 SLIP ROLLER PARTS BREAKDOWN 8422800-080

Fasteners needed to attach Slip Roller to stand are the following: (Fasteners to attach stand to floor are not included.)

Defective parts, of a product manufactured by DI-ACRO, will be replaced or repaired at no charge for twelve (12) months following delivery to the original purchaser. Labor is included for the first 90 days. This warranty becomes void when products have not been used according to instructions furnished by DI-ACRO, nor does it cover any altered parts or unauthorized repairs. We cannot be responsible for the cost of repairs made or attempted outside of our factory. All other warranty claims are made FOB our plant, providing such items(s) is returned freight prepaid to our plant for...