TRION-2402-MULTI TRION-2402-MULTI TRION-2402-MULTI  Universal analog module  Sampling: 24 bit, 200 kS/s per channel  Input types: Voltage, bridge, resistance, RTD, IEPE® Module specifications 4 channels D-SUB connector (CH1 can be used as CAN port) 8 channels 0B LEMO connector (CH1 can be used as CAN port) Input channels ADC – Resolution – Sampling rate Input ranges – Voltage – Gain dri� Typical 10 ppm/°C max. 20 ppm/°C – Offset dri� Typical 0.3 μV/°C+ 10 ppm of range/°C, max 2 μV/°C + 20 ppm of range/°C Input impedance Input bias current Input configuration Single-ended or differential (programmable) Input coupling DC / AC (high pass filter 0.16 Hz) Rated input voltage to earth according to EN 61010-2-30 Isolation voltage (channel-tochannel and channel-to-chassis) Common mode voltage to GNDisolated

TRION-2402-MULTI TRION-2402-MULTI specifica�ons Overvoltage protection Excitation voltage range 0 to 24 VDC freely programmable; separately for each channel – Current limit Continuous short – Load and line regulation ±0.002 % with sense line connected error Excitation current – Compliance voltage – Output impedance >10 MΩ  4-or 6-wire full bridge  3-or 5-wire ½ bridge with internal completion (so�ware programmable) Supported sensors  3- or 4-wire ¼ bridge with internal resistor for 120 Ω and 350 Ω (so�ware programmable)  4-wire full bridge with constant current excitation (piezoresistive bridge...

TRION-2402-MULTI TRION-2402-MULTI TRION-2402-MULTI specifica�ons ADC anti-aliasing filter Typical signal-to-noise ratio, spurious Free SNR, effective number of Bits2) Sample rate Typcial crosstalk Typical CMRR Self test (self calibration) Each channel is able to perform a complex self test by using internal high precision references Channel-to-channel phase mismatch Typically <60 ns between channels using the same range Programmable: high impedance or 120 Ω Input connector 9-pin LEMO EPG.0B.309, 9-pin D-SUB connector – Voltage mode, no excitation – IEPE® mode (4 mA / 8 mA) – Loop powered sensor...