Studio System™ Office-friendly metal 3D printing 316L stainless steel Characterized by its corrosion resistance and performance at both high and low temperatures, 316L is a fully austenitic stainless steel. It is used often in applications involving chemical processing, salt water environments, and household or industrial fixtures. Mechanical properties Studio System™ MPIF 35-MIM3 Wrought4 per standard as-sintered as-sintered (min) for reference Yield strength (MPa) astm E8M 165 140 170 Ultimate tensile strength (MPa) astmE8M 494 450 425 Elongation at break astm E8M 51% 40% 40% Performance Similar standard designations6 Boil test5 (corrosion) astm F1089 Pass UNS S31603 Copper sulfate test5 (corrosion) astm F1089 Pass EN 1.4404 1 Due to the material's high elongation, strain values were obtained from crosshead displacement. In conformance with AsTM E8M, total elongation was obtained from scribed marks on the gage length and yield strength was calculated from extensometer measurements. 2 Properties shown reflect beta processing parameters. 3 Per MPIF standard 35, Materials standards for Metal Injection Molded Parts (MPIF 35-MIM, 2018). 4 Wrought values based on AsTM A240 standards. 5 Prior to corrosion resistance testing, all test samples were machined and passivated in accordance with AsTM F1089. 6 Listed designations are for reference purposes only. Composition and mechnical properties may vary. End-use material performance is impacted (+/-) by certain factors including but not limited to part geometry and design, application and evaluation conditions, etc. Copyright © 2019. All Rights Reserved. subject to change without notice. DM-0011 v1.0 02-19 Desktop Metal, Inc. 63 3rd Ave, Burlington MA UsA 01803 www.desktopmetal.com