Catalogs >
DEPRAG SCHULZ GMBH u. CO. >
RECYCLING Drivers

RECYCLING Drivers
2Pages

Catalog excerpts

Screwdriving Technology Automation Air Motors Air Tools RECYCLING Drivers For the easy disassembly prior to recycling and repair nn perfectly balanced and ergonomic handle nn economical nn durable The RECYCLING screwdriver is a specially designed tool for repair and recycling operations. Especially when recycling electronic scrap material, a mechanical disassembly is required prior to the handling of chemical and thermal material. In most cases that requires the loosening of different screws. The big challenge for a screwdriver is: • to engage the screw drive with a bit • to apply the required down-pressure right from the start, to avoid cam-out or ratcheting • to reach a higher loosening torque and therefore breakaway if screws are rusted, etc., which has a direct impact on the operators hand The ergonomic housing grip is designed in accordance with the newest OSHA-requirements and helps to absorb the torque reaction force. Furthermore, the lower housing flares out [bell bottom] to simplify the required push to start. According to the required drive direction and the most positive support-grip, a technical clean solution is: Handheld Screwdriver pneumatic for special applications RECYCLING screwdriver for horizontal disassembly: For the horizontal disassembly we recommend the use of a screwdriver without clutch in pistolgrip design. The screwdriver is started by an ergonomic trigger. The bit change is done by an integrated quick change chuck. The RECYCLING screwdriver operates as follows: Set driver, engage bit, push trigger and tool will start and screw-connection is loosened. Backout torque reaction can easily be absorbed by the pistolgrip form. RECYCLING screwdriver for the vertical disassembly: For the vertical disassembly we recommend the use of a reversible screwdriver with straight design. The start occurs in 2-steps. Possible backout torque reaction is limited by the adjustable, left-rotation safety-clutch. The bit change is done by an integrated quick change chuck. The RECYCLING screwdriver operates as follows: Set driver, apply small downpressure to engage bit with screw drive at reduced speed, apply full down-pressure and disassemble fastener.

Open the catalog to page 1

TECHNICAL DATA Straight Motor Size 2.5 Screwdriver Style Screwdriver, left rotation reversible to right rotation Torque max. (loosening torque) Speed, idling Air consumption Distance from spindle centre to side Length Weight Noise level Air hose dia. Air inlet pipe thread size Internal hex. drive DIN ISO 1173 Quick change chuck, mounted Pistol grip Motor Size 2.5 Type Part no. Nm / in.lbs rpm m3/min / cfm Performance data relate to an air pressure of 6.3 bar (90 PSI) Hose coupling with nozzle and nipple Set of torque adjustment tools Set of clutch springs Hose coupling with nozzle and...

Open the catalog to page 2

RECYCLING Drivers 2Pages

Catalog excerpts

All DEPRAG SCHULZ GMBH u. CO. catalogs and technical brochures

RECYCLING Drivers
2Pages