Features Total 400W IR of Heating Power- Ensures the heat is saturates evenly and smoohly over multilayered PCBs allowing for fast manual soldering PCB Holders and Bottom-side supports included-allows for set up and use for preheating without the need for additional purchases of accessories. Wide Area Heating Design- The large area heating helps prevent the board from warping due to uneven heating. Designed for use with SD-3000II- This pre-heater is also designed for use with SD-3000II Fast Efficient Pre-heater The pre-heater uses 2x 200W IR heaters and closed-loop control to enable fast and safety manual soldering The pre-heater is designed for multilayer PCB under Lead-Free solder with large heat sinks. Combined with when Soldering lead free This pre-heater is also designed for use with the SD-3000II to prevent PCB warpage

Main Body Power Cable Specifications PCB Holders and Bottom-side supports included-allows for set up and use for preheating without the need for additional purchases of accessories. Heating Method: Infrared Heating System, 200w x 2 Temperature Setting Range: 100℃～230℃ (Sensor Feed Back Method) 350mm wide x 62mm high x 295mm deep Dic Trading Co., ltd. 1-26-10, SEKIMACHI HIGASHI, NERIMA-KU TOKYO 177-0052 JAPAN. TEL:+81-3-3929-6800 FAX:+81-3-3929-7441 Web: www.denondic.co.jp Manifacturer: Den-on Instruments Co.,ltd