NEW IDEAS IN MOTION CONTROL... This single-axis, Direct PWM amplifier is designed to fit into a standard 3U UMAC rack. It is intended for driving AC induction, permanent magnet brushless, linear, and brushed DC motors. It has a current rating of 8.0 A Continuous/16.0 A Peak. This drive will operate directly off of the power mains wired to the backplane, typically 110 VAC or 230 VAC, three phase or single phase with appropriate derating. An external power supply of +24 VDC @1A (regulated or unregulated) is required for logic power allowing the user to control motor power separately from control logic power. The amplifiers are interfaced to a PMAC controller via ACC-24E2, ACC-24E2M, ACC-24E3 (Power PMAC only), ACC-8F or ACC-8FS. These drive amplifiers are designed to receive logic-level direct digital PWM motor voltage command from the PMAC controller and convert them to high voltage for motor control. They provide the power conversion, motor current sense feedback to the PMAC controller, and comprehensive system protection. Each drive also accepts motor thermal overload sensors for drive shut down on motor over temperature. The host controller provides all other motor control functions. HARDWARE FEATURES Amplifier Output Current Ratings

8.0 A Continuous/16.0 A Peak Output Power Ratings 1.912 kW (2.564 HP) Types Supported DC Brushless (Permanent Magnet Synchronous) AC Induction Hardware Features 1 amplifier channel Simple wiring High power density Extensive fault protection Locking motor connectors Closed loop hall effect current sensors Direct line connection with Soft Start Separate logic power and motor power 3U UMAC Rack format for small size and easy support Full isolation for PMAC and user interfaces Direct PWM control for best performance and cost Shunt Regulator (requires external Resistor) for Bus power control...

CABKIT3C - Cable Kit for 3U Servo Drives CABPWM-1 - 600 mm (24 inches long) PWM Cable for 1-Axis CABPWM-2 - 900mm (36 inches long) PWM Cable for 1-Axis CABPWM-3 - 1.5 m (60 inches long) PWM Cable for 1-Axis CABPWM-4 - 1.8m (72 inches long) PWM Cable for 1-Axis CABPWM-5 - 2.1 m (84 inches long) PWM Cable for 1-Axis CABPWM-6 - 3.6 m (144 inches long) PWM Cable for 1-Axis GEO Drive Motor Power Cables - 14AWG Motor Power Cables Connector CONKIT3C - 3U Amplifier Connector Kit Regenerative GAR78 - 300W 78 OHM Regenerative Resistor with Thermostat...

Geo 3U Servo Drive Amplifier - User Reference Manual