Phone: 772-465-4302 Toll Free: 888-500-2755 ICESL DRIVER WITH INTERNAL COUNTER ICESL BRUSHLESS DRIVER with INTERNAL COUNTER 32V / 40VDC Brushless Motor The Delta Regis ICESL Series tool integrates the performance of a DC Shut-Off Clutch Brushless Screwdriver with a programmable, handle-mounted Batch Counter. Each tool includes a 2m cable to connect to a 32V or 40VDC Power Supply (sold separately). • Batch count value can be set from 0-99 screws/batch. Screwdriver will count down by one each time a good fastener rundown is completed. LED display shows current screw count value and displays the available options and setting values during programming mode. Programming buttons are located on the driver directly below the LED display. Buttons are used to set-up parameters prior to using the screwdriver for assembly. Programming mode can be locked by pressing a preset combination of buttons to avoid accidental program changes. ‘Clear’ button allows the count to be manually reset to begin a new batch. Min and max rundown time settings allow the user to establish an acceptable time window for fastener installation. Only fastener rundowns which occur within the specified window will be accepted as good (OK) and cause the count to increment. Rundowns completed outside the time window will be considered no good (NG). This might occur if the screw was cross-threaded (time too short - below min time) or stripped (time too long - greater than max time). Visual and audible indicators are available to let the operator know if the rundown was OK or NG, and when the batch has been completed. Screwdrivers can be hard-wired with additional output signal cable (included in box) to output rundown status (NG/OK Batch) to a PLC. ICESL6 Drivers with Internal Counter Start Type Range In.Lbs Model Number Use with Power Supply model BECT620C or BECT620IC (‘F’ fast tools) (see pg 9)

Phone: 772-465-4302 Toll Free: 888-500-2755 Controllers for 32VDC Brushless Drivers Model Number (1) Outlets Speeds Tool Connector Part number with North American cordset. For EU cord, add suffix ‘E’ , UK cord add suffix ‘UK’. The ECT6-SSOA-C Control Module allows you to add “Adjustable Slow-Start” and “Output Signal” capability to your Delta Regis CESL6 Brushless Screwdriver. This external control module plugs in-line between the BECT620C/IC controller and a CESL6 Series screwdriver. Accessories Select driver model no. on the right, follow column down the chart; X signifies an appropriate accessory....

DELTA REGIS Controller model BECT640HL provides the power required to run all models of high torque 40V DC Brushless Series Screwdriver. This includes tool models ESL628(F/P/PF) thru ESL665M(PM) and models ESP635-665. CE/RoHS/ETL Approved. ECT6-SSOB SLOW-START MODULE BECT640HL HI/LO SPD CONTROLLER Power Supplies / Controllers Model Number Tool Connector Use only with Screwdriver Models Power supply shipped with standard North American cordset. For EU cord, add suffix ‘E’ ; for UK cord, add suffix ‘UK’. The ECT6-SSOB control module adds “Adjustable Slow-Start” and “Output Signal” capability to...