The Kwik-Chek orifice gauges are designed for the rapid measurement of small hole diameters. Models are available to cover a range of hole diameters from 0,010” to 0,255” (0,25mm-6,50mm). These gauges work on the principle of directly transferring diameter measurements from a sliding, tapered needle to a linear scale readout graduated in 0,001” or 0,02mm. FEATURES q No skill required. Untrained personnel can make fast and accurate measurements. q Rapid and simple calibration. A setting master is provided with each gauge. Permits rapid periodic check on calibration and field readjustment, if necessary, by shop personnel. q Magnified, direct reading scale permits easy reading of hole diameters to nearest 0,001” or 0,02mm. q Precision ground tapered needle is made of 52-100 Steel and Chrome plated for maximum wear resistance. q Positive Clutch which locks needle and scale at exact dimension of hole being measured. q Convenient pocket size and weight makes these gauges ideal for roving inspectors and engineers. SPRAY DRYING TYPE KWIK-CHEK ORDER EXAMPLE Please specify the model number and Inch or Metric size when ordering. INDIVIDUAL GAUGES Model Number Hole Size Range Inches Metric Note:- Kwik-Chek orifice gauge is not suitable for Mini-SDX. Contact our Helpline for any special requirements: Tel: +44 (0) 151 424 6821 Fax: +44 (0) 151 495 1043 e-mail:[email protected] Web:www.delavan.co.uk